Got the following code on the burban. P1654 Service Throttle Soon Lamp Control Circuit. Please tell me it was only needing the bulb replaced on the instrument cluster! Thanks.
My fuel gauge has gone crazy! Not the sending unit or the grounds just put a new tank and sender on it. Can the gauge itself be replaced? I found a complete cluster but miles are off how do you change out the odometer between the old and new one or can you do that?
Did this project couple of weeks ago and wanted to share if anyone is interested in DIY rock guard. I put Herculiner on the bottom door panels and painted it for around 65.00 compared to 600.00 at line x. I think prep is key and sanding enough to get a good working surface. I used 2 coats of...
My power steering pump bit the dust about 3 weeks ago. Replaced it and the new one it lasted about a week before making a groaning grinding sound. Well I replaced that one and the 2nd one didn't make it two days before taking a crap! The pump came from Autozone so the manager felt bad and is...
I changed out my lift pump with a higher psi one I found. I had to find another place to mount it because it was longer so I used the bolt under the cab coming through that holds the drivers seat down to mount Lp on. (didn't want to cut any of the fuel lines till I got the bugs worked out) Took...
I have been having this issue with the brakes on the burb. Every time it rains the abs starts going crazy and will engage with the slightest push of the brakes and then act perfectly fine after it gets done spazzing out? I have replaced lines, calipers, pads and checked for any air in the lines...
I have noticed that sometimes when I floor it or hit the brakes my volt meter dumps but recovers quick. (almost like morning start up when the glows kick back on) It just has done it a few times now. I have new batteries, load tested them, 4 gauge wire from the alt. to battery checked all the...
Just leaks enough to be annoying! Always around the starter and passenger side of the tranny dust cover. I have done the following....Replaced all the return lines on that side with the good stuff, new filter manager, tighten all the fuel lines, return lines to and from ip behind filter no fluid...
Stop by walmart ran in got a few things ...........when I came out it wouldn't start Turned over like it always does nice and fast. Went home got another truck came back after 30 or so minutes and it fired up like nothing was wrong and no SES light.
Did this while not starting...Changed the pmd...
Well I was checking the Burban today and noticed a small amount of oil that appears to be coming out of the exhaust manifold where it connects to the engine 1st cylinder passenger side. Any ideas? Should I worry? No weird noises and runs fine.
I had an injector leaking where the injector treads the two sections of the injector together. I got a new bosch rebuilt injector got it installed and dang if it at leaking at the same place! Pull it back out and almost busted a blood vessel tightening the injector sections. Put it back in and...
Can the fuel lines that run under the intake to the IP and water drain valve be re-routed to the top side instead of the engine vally? Has anyone done this? Just seems it would be easier to keep an eye on them and much cooler for the hose wear and tear.
Anybody experimented with changing out resisters to see if you can get more miles per gallon? I have a #7 #5 #3 resisters. Would changing from the #7 to the #3 increase mpg by decreasing fuel or would it take something else with it? I don't do any towing with the suburban. Any input would be...
I am going to change my fan clutch and fan over to the Duramax fan set up but I was wanting to know if anyone has done this on a suburban and has there been any clearance issues? The new fan setup is 21 inches mine is 20 inches but my shroud messures 22 inches. With a plastic fan blade isn't...
Today my wait to start light stop working. Can still hear the glow plug relay working. Pulled the instrument cluster and swap light so light is not burned out. Anyone have a clue what else it could be? Glow plug relay going bad? Truck starts fine.