Search results

Gregg, What do I need to do a dual remote oil filter set up on the 6.5 n my sig. Thanks

What fitting is used for the top of the IP. I had an old IP so I have already enlarged the holes under the filter screen inlet. I can't seem to find a fitting that is larger. What am I looking for. BTW I plan to use the Walbro FRB5-1 to complete the project. Thanks for any help!

What does it mean?

Just finished my second tank of fuel with the chip. Between the two milage is up about 1&3/4 mpg. Not bad considering first tank really did not stand a chance. That brings the truck in my sig to just under 18 mpg.

I seem to have a knocking coming from my #4 injector. You can feel the vibration on the injector line. This seems to be only at idle or slightly above. When I use my GMTDScan software and turn that injector off the sound goes away. Would this be a good indication of a bad injector? My truck...

Is there any way to check/test the engine coolant sensor?

Well, I just posted this on the place by accident. Forgot where I was at as it's been one of those days. When I turned my defroster on today the air continued to blow on the floor. No matter where I turned the control it never changed the airflow. The AC does not work either. I still have all...

How do you tell what kind of turbo you have. GM 4, GM 8. What identifies them. I know the one my truck is not the original.

Where can I get one that is the right size? The one on mine is for a gasser.

What can you tell me about them?

I need to do some welding on my chassis. Is there any precautions I need to be aware of concerning electrical?

I am getting the TCC PWM solenoid circuit error code. What can cause it, how can I find it, and where is it at? The torque converter seems to lock just fine but, I don't know. I can't clear the code. I have the TCC manuel lockup mod., will this have anything to do with it? Thanks for any help.

I've read and read and I can't figure this out. My timing is desired 9.5 and actual 9.5 with the TDC offset at -2.02. What do I do? I am getting a TDC offset error. I am also getting a code 83: TCC Solenoid.(related or not?)

I am getting ready to install a tank type engine heater on my truck and I was wanting to know where I could find a drain plug on the lower block. There seems to be a plug of some sorts beside the middle freeze plug. Would that be it or what would be the best way to go about the installation as...

Can anyone tell what the thread size is for the nipple where the injector line connects to the injection pump?

Dumb question, where do I tie my gauge lights in so they will dim and brighten with the rest of the dash lights. Thanks!

Was just wondering, when I remove my vac pump is the bracket that it is mounted to still necessary to support the AC compressor or will I need to pull the pump and then put the bracket back. Thanks!

Where can I find a wiring diagram for the pin outs for the computer. Thanks

I've read this at many places but want to be sure. On the truck in my sig. what belt would I use if I removed the Vac. pump. Thanks!

My ABS light came on today. Where do I start?