6.5 running like crap after new IP install

[jrsavoie]

will do

I use the license plate bolt.

A lot of times they were long enough I could add a nut and washer.

Depending on the heat sink, sometimes I would have rivet a piece of aluminum angle or something onto the heat siink to get it mounted the way ai like.

I took to mounting a heat sink and PMD inside each bumper nostril and running 2 extension cables up to the intake.

That way, I could swap PMDs under the hood instead of getting down on the ground

 

[MrMarty51]

I use the license plate bolt.

A lot of times they were long enough I could add a nut and washer.

Depending on the heat sink, sometimes I would have rivet a piece of aluminum angle or something onto the heat siink to get it mounted the way ai like.

I took to mounting a heat sink and PMD inside each bumper nostril and running 2 extension cables up to the intake.

That way, I could swap PMDs under the hood instead of getting down on the ground

I have 3 behind the bumper. No vent hokes in my bumper.
I labeled the connectors 1, 2 and 3 so if I have to switch at the IP connector I know which one I switched to and which one went bad down below.

 

[jrsavoie]

I have 3 behind the bumper. No vent hokes in my bumper.
I labeled the connectors 1, 2 and 3 so if I have to switch at the IP connector I know which one I switched to and which one went bad down below.

Good idea. I never marked mine

 

[MrMarty51]

Good idea. I never marked mine

With two it might not be such a problem, until its time to remove the faulty unit.