Anybody have a line on dead PCM's? I need a couple different ones.
Any Hummer 6.5TD 96- 01 version will work on the one hand.
The other one i really need is OBD1 from 1993-95 and is not found in Hummers but in heavy duty GM pickups that use the 5068 IP's. Part# 16183977 ECM (1994-1995) or...
LOL anybody want a case of frams! I bought a pile of them when they were on sale stateside. Now after reading this thread not sure if i will continue using them. I am only on my second one out of the 12 i bought. I haven't noticed any issues yet. Prior to that i was using the AC Delco's for...
Gee Matt, Im surprised an energetic guy like you hasn't got out the bbcue, Muggy 77 eletrodes and some Lock N Stitch yet LOL
What a drag!!Engine was looking good. You gonna pull the pan off for shits and giggles. I think it worth a look and you can nudge the bolts. Be interesting to see how the...
Gee Matt, Im surprised an energetic guy like you hasn't got out the bbcue, Muggy 77 eletrodes and some Lock N Stitch yet LOL
What a drag!!Engine was looking good. You gonna pull the pan off for shits and giggles. I think it worth a look and you can nudge the bolts. Be interesting to see how the...
First i have ever heard about a different gear set for our hubs. There is a 12k from 10k upgrade but as far as i know the top gear change is only to facilitate the larger updated input CV shaft. My diffs are Torsion 1 and are a 2:56 ratio. Wouldn't change a thing at this point. Truck runs very...
I have my fuel pressure sender right above the IP within 3 inches of the input. I have an air bleeder there as well. I float my pressure manualy from the dash using a PWM controlled Raptor 150 30psi pump which also has a manual internal output PSI set feature... Over the last 5kmiles i have...
Hey guys. I working on a small project and need to measure engine oil temps or get some data on what our average peak oil temps might be. I have not been able to find any info as of yet. Wondering if anyone here has installed a temp sensor for this and where is the best place to install it to...
Changing resistors at random will do nothing without going through a calibration sequence and in fact could set a code. Its not the PMD in my opinion.
Fix the lower number codes first,, in this case the low coolant sensor, sometime the higher ones will dissappear.
The next three codes up are...