Search results

I've got an electrical gremlin in my 4WD...bought a new actuator to 'fix' it, plugged it in without installing it and it didn't engage. Unless I did it wrong. I even started the truck and put it in 4WD, it did not engage. Does anyone have a schematic of the 4WD electrical they can post for me?

OK, so until now my truck has never had an issue starting in the cold. Maybe it's just too cold? I thought my fuel had gelled. Nope, I'm getting fuel to the manager (at a very healthy flow, I'll add) and I cracked an injector line. Getting fuel there. My glow plugs are all working (It...

Ok, dumb@$$ question here: I forgot to add my additive with the last tank of fuel I put in. And it got mighty cold here last night. Tried to start my truck this morning and she wouldn't go. I suspect that my fuel gelled. Will it degell as it gets warmer? I didn't have time to actually...

So I am going to be doing a manual IP conversion on my truck. Since my rig has a manual transmission, as far as I know, when I ditch the DS4 I long longer really have a need for the ECM, so I was considering rewiring my truck to do away with the ECM all together. The only question I have is...

So I just found some time to finally do the Battery Mod today. Good Lord, what a difference. I got some 3/8" x 2" hex bolts, nuts and washers. Took the wire wheel on my dremel and cleaned the hell out of all of the battery contacts, put some dielectric grease on the newly cleaned contacts...

I've been cursing like a sailor for the last half hour. So my rig developed a coolant leak in the last week. I traced it back to the passenger side of the thermostat crossover. No biggie, I'll pull it off, clean up the gasket material real good, slap some new gaskets on and be good to go...

OK, all, got a problem. I've done a TON of searching on the other place, but just need to bounce some ideas off of everyone. Long story short, my rig has a knock. It doesn't occur right away, usually after a few minutes of the engine running. It comes on gradually, starting with a single...

Anyone know the part number/know where I can get ahold of/want to sell me a block heater cord? My block heater is iss till there, but there is no chord for it.

Well, as if things weren't great enough, I think I have a cracked head or a cracked block. I have no evidence to support this other than the fact that I am using coolant and I do not notice any leaks. I will have to do further investigation. If it's a cracked head, it's not that big of a...