Search results

:mad2::mad2::mad2::mad2::mad2: Installed HID's on my 2011 and they just will not stay lit! They are the 35watt 6000K kit. I first tried the kit with out the harness. Worked fine for a while and then it started flickering and then just going out on one side, usually the drivers side. So I...

Look what fell off the UPS truck today!:eek: Thanks Chad! Install happens tomorrow along with new torsion keys, lower ball joints, pitman, idler and outer tie rods. I'm getting this stuff out of the way so I don't have worry about it and hopefully the alignment will hold again. Also washed...

Good to see all you folks over here. I'm came for the popcorn :pop2: :D

Does the 06 have one? And if so where is it located?

Ashton, does Amsoil make a dino 15-40?

Thats right, 87k on the clock. Trans coolant lines started leaking last winter. I had forgotten about them until now as I am going to have the tranny built. Called the dealer to see if GM was doing anything about them, they said no. My service writer told me to call customer service and see what...

So yesterday I decide to replace the ISS. No big deal. The hardest part was just getting to the bolts to remove amd replace the shaft. While I'm under the dash I also replaced the column bearing. As I'm doing this I end up turning the steering wheel. As I see it turning around I'm thinking...

I finally broke down and bought a new hitch for my truck. The stock one was showing signs of stress and the pin hole is now oblong instead of round. I also never have had much faith in the round bar hitches like I have stock. I wanted a Putnam XDR but putnam is no longer around, or so the...

Anybody got the part numbers for the ISS and new bearing from GM? Mine is rattling terrible since I put the new shocks on.

A friend of mine ownes a large private repair shop and they use a lot of BG products. He told me about a new BG synthetic transmission fluid. Said it meets the TES-295 spec for the allison 1000. I have seen the spec sheet from BG but do not have it in hand. It is also compatible with Transynd...

Anybody been to Pigeon Forge TN? We are thinking about going over the kids spring break. I'm curious of the better campgrounds to stay in. Thanks

My wife ordered a complete set of Bilstein shocks for my truck. I gave her the link and part numbers from Nor-Cal Truck. I wanted the 0"-3" zinc 5100. That is the part numbers I gave her. Actually I gave her the NCT custom package. My question is this: I got ford F250 front shocks and Dodge 6"...

This is for a friend who has an '03 CTD. he has 222,+++ miles on the truck. He is losing the prime in the fuel lines when he turns the truck off. He can start it with ether and it runs fine after that but when he turns the truck off it will not start again. The lift pump has been replaced and...

Last weekend I removed the K&N filter charger kit on my truck and went back to stock. I removed the vortex fins and put it back in. What I have noticed is less throttle response from idle. A little more smoke and seems to have a little more boost when cruising at highway speeds. I have also...

Well I bit the bullit and bought a new bike. I sold my Rhino a few months ago and have not replaced it with anything yet so I decided this weekend was as good as any. Picked up an 07 Can-Am Outlander 650. It was a left over. Rode for 5 hours on Sat. This bike is nice. Much better than the...

I could not take it anymore! The squirmy feel of the Nitto Terra Grapplers was rediculus. They felt like they were rolling over on the side wall in corners and heaven help you if you had to make a quick lane change. I had 285-70/17 on H2's. E rated. these tires were way to soft for a 3/4 ton...

I see the beans got spilled and everyone started moving there lockers over here. Good to see ya I'll fill out sig and such later, gota go to work.