Remote fuel filter

[mr.clopek]

Want to install remote fuel filter on 93 6.5
What is procedure to access or remove inlet fuel fitting on back of db2 pump
Remove intake or some form of crows foot?
What goes on once factory fitting is off?
AN fitting?
Thanks for any advice/info
mr.clopek

 

[Twisted Steel Performance]

You could just use the fitting that is on the pump and connect new hose to it...

 

[jrsavoie]

Want to install remote fuel filter on 93 6.5
What is procedure to access or remove inlet fuel fitting on back of db2 pump
Remove intake or some form of crows foot?
What goes on once factory fitting is off?
AN fitting?
Thanks for any advice/info
mr.clopek

If you're there, it would be a good time to install a permanent fuel pressure gauge

 

[mr.clopek]

Could but want to use a an with push loc
Looking for info to remove fitting from pump looks like I may remove intake to do a good job job!
Thanks

 

[MrMarty51]

Could but want to use a an with push loc
Looking for info to remove fitting from pump looks like I may remove intake to do a good job job!
Thanks

Welcome to the forum Mr. Clopek.

Intakes is not a bad job to get removed.
If You could do some test fitting and then get an AN swivel fitting that has the port with 1/8th inch pipe threads, then, screw jnto that port a barb fitting, run out a remote hose and install another barb fitting into that end of the hose, then the option is in place to install a fuel pressure gauge at any time without having to remove the intake again.

 

[mr.clopek]

Like that idea of gauge!
Also had another option maybe.
I have left over parts off 82 Chevy Luv 4 cyl. Diesel thinking I could use the fuel filter housing off that and make bracket to mount a remote filter the micron rating on that wix filter 33128 is 10 micron and rating on factory replacement wix 33976 for 6.5 is 14
All I need to do is buy some fittings and intake gaskets!
Right now my original fuel housing is leaking out bottom either pin hole or fuel past wires.