I don't have my Truck any more so don't need the cable
$200 or best offer works on 94-95 6.5 Diesels
I have my Authorization codes in a email from when I bought it
Thanks
you can email me direct to [email protected]
The EMC I ordered from Bison came yesterday. I put my Chip in it and installed it in my Suburban and the glows worked Correctly
Thanks so much for your help
even is the temp sensor was not sending a signal the truck should run max time.. I think its around 30 seconds of Glow
I'm having a hard time finding a Computer in my area. tomorrow I will check all of Canada
So I have traced the yellow wire to the Computer and cut it to check for it getting power from a short... It is dead and the Computer is sending 12V down it all the time the key is on..
So now I need to find a computer from a 94-95
I've Checked that the relay unlatched with the key off so its not stuck.
It seems to me that there should not be 12V on the Pink wire?
I know last year I was looking to see if I could use the Trucks Signal to run my relay but it would not work.
I am going to see if I can find a new Computer and...
Yes its connected correctly. I started getting a SEL with code 29 Glow Plug Relay even though I have not had one installed for a year. with the Key on I have 12V on yellow and Pink Wires even after I start it.
So I finally Got a new Glow plug relay because the wife never remembers to use the manual one. So I install it and now I get glow when ever the key is on even after it starts? I checked the harness and there is 12V on 2 wires and nothing on the third when ever the key is on.
Does any one...
So Removed my glow plug relay and put in a button to run it..
I was fine but now I have a service engine Light so I am thinking I will need to replace it.
Thanks
I bought a turbomaster from Warwagon in the Spring and just got around to installing it.
I looked at heaths site for the instructions but there was a dead link to them. I emailed them yesterday but did not hear back
Any way there are 2 holes that the arm for the gate can be attached the one...
I have a 95 suburban with just under 500000KM on it that I picked up for pocket change because the PO thought he should leave it idling like the Rigs do.. He also thought synthetic oil was a scam but 10000km oil changes were fine with dino oil.
That engine had so much blow by that you could...
I recently replaces the rear shocks with a set of Bliston HD and found that they shook the bolts off the Body.. I was wondering if any on new the size so I could get some new ones and lock tight them in.
I know the Socket was 13MM i believe
Thanks
The Suburban is a C1500 with SF Rear axle 8 Lug Wheels and 13X4 Drums It has 2.5 Shoes but I'm not sure they are Correct and it should have 3.5" shoes?
Thanks again?
Where you thinking of keeping the original pump the feed the new one?
I had this though as well because the original pump will flow even if it is now working and I don't think it would restrict flow
I would go:
From Tank to Original to 10micron filter to Walbro to 5Micron to Original Filter...
So I have a 95 Suburban that I broke a rear Break line in and Started replacing it
The Connection on the Rubber Hose was rotted out and all the Bleeder are frozen so I have to change the Rear Brake cylinders as well. Now I notice that the Drums are way out of spec (almost 13.2") so I need...