I know it sounds crazy but I had a similiar problem, changed LP three times , dropped tank and checked sock, changed PMD to remote and harness, changed IP. would run great for a week then always go to secondary fuel..
I changed my Cranshaft Position Sensor and it fixed it.. You can always try...
On my job you need a knife for " BackUp" just in case! I have a Microtech LUDT auto like this http://www.notyourmamasknives.com/components/com_virtuemart/shop_image/category/resized/LUDT_4aeb0c2d5e4c9_200x200.jpg.. Best knife ever and I believe it's better than a benchmade which Ive also owned...
Hey Bigchevy, I noticed you live in Avon Park,Fl.. My family moved down there from the north about 15yrs ago and I go and visit them every year..
My mom lives on E. Camphor St. and my sister and family live near the high school.. Small world Huh !:thumbsup:
Leo, I tried the best I can ..I'll really try and dig it out when I get a chance.. Do you think I should say F*** it and by a Cable from PMDcable instead . atleast I know his stuff is good. Might be a worth while $38 investment??
I have done numerous checks .. I dropped tank and checked fuel sock ( perfect) the Sending unit was replaced 3months ago along with lines and I just replaced the LP for the 3rd time. The FM is new along with filter.
I did check voltage when it was pumping and it was fine.
Another code does...
The LP appears to be running fine I connected a voltage meter to it and it was 12v with the key on..I changed it to a 93LP and redid the ground. Sorry I don't know how to do more things trying to learn.....
I haven't checked the new pumps pressure yet but appears to be normal.
I don't...
The truck is running somewhat better now that I figured out that the Fuel filter was either cracked or wasn't tight and leaking air into the system causing it to stall and die.
I replaced the LP once again with a 93 LP, which wasn't that expensive. before I did this I checked the voltage to...
My truck still isn't right . I plugged in a code checker from Advanced and it brought up the folowing 3 codes:
P0231: Fuel Pump second circuit low
P0251: Injection Pump Meter control
P0251 : Injection Pump meter control ( Pending)
I got the 93 LP and am going to install it probably tomm...
Ok , I believe my truck is fixed. Long story short I believe the fuel filter was either cracked,not seated properly or had a bad gasket and was leaking air back into the system.. Thats all corrected and the truck isn't stalling or bucking anymore.
However it still has the P0251 code and is...