Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
that sounds like what i would do if i was to drop a 4L80 into a non TCU truck.
I have done the switches twice now. First with the old 93 manual pump truck. Employee had messed up when dropping last 6.2 in. Exhaust leak burnt up wiring which ran the 4L80E. It was an old work truck and I was stuck 200 miles from home with trailer on. I knew how to wire it so I spent $5 on 2 rocker switches. And got me home. Drove it for a year like that until last January when the motor chunked again. Junked the truck to raise quick cash to buy a 98 5-speed truck! For the trans! Also had a good 6.5 in it! $600!
The 5-speed is for the 01 gas convert that I drive every day. Thats right I have an 01 with an DB2, turboed 6.5( formerly a 6.0 gas!)! I tried everything(I knew) to fool the newer ecm into believing it could shift the 4l80e. Its a 4wd. I got the speedo working and some other stuff but just couldn't do it. I wired it for switches and run it hard every day. Truck weighs 10k with the trailer empty. Hauled a 580 SuperE extendahoe last week! With my dually down I will continue to drive it this way. Gotta have a truck and not ready to convert to 5 yet!
My point is the trans seems to hold up fine shifting this way. I would love to make a paddle shift for it! I run the converter by switch as well. With the cost of even the cheapest controller being what it is( 550 or 650 from TTS vendor was the cheapest I found) I will keep flippin my 2 switches!
I am gonna read that pdf and see if I can setup something cleaner for mine! Thanks for posting!