coxpn2
coxpn2
I'm hoping there is an obvious solution to this problem, which doesn't involve me dropping the tank AGAIN. But probably not, haha.
I recently replaced the sending unit with a spectra - I cut the threaded fittings off and hose clamped rubber lines for supply/return. After which I filled the tank and drove it for around 400 miles.
This morning I fueled up again, at my normal station, and let the pump shut off where it wanted to. (Didn't top off or anything like that, just let it click off). If I looked down the filler tube I could see foam so figured no top-off was required.
I drove about 5 miles home and parked on a level surface. When I went out a couple hours later I could see fuel dripping right in front of the trailer hitch/bumper. If I look up in there it appears to be dripping off the back edge of the tank. It's maybe 1 drip every 10 seconds or so... maybe a cup every couple hours?
My question is - where is this coming from? I have a couple theories, but I'm looking for ideas... If it dripped right after I did the sending unit it would make sense I didn't seal something right or tighten a clamp, but this is the 2nd time I filled up. Any thoughts?
I recently replaced the sending unit with a spectra - I cut the threaded fittings off and hose clamped rubber lines for supply/return. After which I filled the tank and drove it for around 400 miles.
This morning I fueled up again, at my normal station, and let the pump shut off where it wanted to. (Didn't top off or anything like that, just let it click off). If I looked down the filler tube I could see foam so figured no top-off was required.
I drove about 5 miles home and parked on a level surface. When I went out a couple hours later I could see fuel dripping right in front of the trailer hitch/bumper. If I look up in there it appears to be dripping off the back edge of the tank. It's maybe 1 drip every 10 seconds or so... maybe a cup every couple hours?
My question is - where is this coming from? I have a couple theories, but I'm looking for ideas... If it dripped right after I did the sending unit it would make sense I didn't seal something right or tighten a clamp, but this is the 2nd time I filled up. Any thoughts?