4L80 dust cover

[Twisted Steel Performance]

Would anyone know the part number for a 93 diesel 4L80 dust cover, seems their are several different ones.

 

[3500GMC]

I can look at my 93. Trans needs to come out anyway. Unless the number is on the outside I can shimmy under it and lay eyes on it... if there is a casting or part number.. That I do not know for certain.

 

[Twisted Steel Performance]

I can look at my 93. Trans needs to come out anyway. Unless the number is on the outside I can shimmy under it and lay eyes on it... if there is a casting or part number.. That I do not know for certain.

Thanks but I found a cover .

 

[dbrannon79]

I need to find one for mine at some point. were the 95 years cast aluminum or punched sheet metal? I wonder if one from a 4l60 would fit off a gasser in the bone yards

 

[Twisted Steel Performance]

4x4 - aluminum
2x4 - sheet metal

From what I found a 4L60 won't fit a 4L80

 

[Will L.]

I wonder why the hmmwv/hummer did the sheet metal with all of them being full time4wd.

 

[Stoney]

I've gotta drop my crossover pipe to change a exhaust donut so I'll finally get to put my cover back on.. it's been off since I changed the tranny.. forgot about it until after everything else was back together

 

[JayTheCPA]

FWIW, after the P400 install, my slushbox ran commando until I did the manual conversion. Girdle on the new engine was incompatible with the cover and I was too lazy to grind the cover to fit.

Might have gone the extra effort if the Burb saw any notable offroad, but it was mostly a highway Queen.

 

[Twisted Steel Performance]

FWIW, after the P400 install, my slushbox ran commando until I did the manual conversion. Girdle on the new engine was incompatible with the cover and I was too lazy to grind the cover to fit.

Might have gone the extra effort if the Burb saw any notable offroad, but it was mostly a highway Queen.

I saw your other comment about that, I'll be trimming it to fit...