I got it figured out. I had to make a bracket that put the pump over the drive shaft. It worked out pretty well. I didn't want to put it on the outside of the frame so I saw no other choice.
Phil
I can't see if it is a nut or a plate. Might not be a nut at all. If it's a welded/threaded plate I will have to cut off the bolts and replace them
Phil
They are 6" inside the X-member and I can't get to them. My mig or tig won't reach and I am afraid if I do it with the stick I will weld the bolt to the nut and be screwed either way.
Phil
I need to get my bed off my truck and I can't figure out how to get the bolts out without the nuts spinning in the x-members. How can I grab the nuts. I will be welding tabs to the nuts before I put them back in so they don't spin. Thank's
Phil
I am trying to install my Air Dog 150 on my truck and I seam to have a little problem. My truck is a reg cab long box and that means I have a 34 gallon fuel tank. I have no room on the frame rail to mount the pump. Has any one installed one of these with this problem. Where did you put it...
I believe the work on the truck is done. A bigger turbo would mean head studs and other motor work. If I won't be able to get a turbo to spool up faster than what I have I will probabaly leave it alone. It is running about 32psi right now and I didn't think the motor would put up with much...
They say that the Edge with Atittude would limp the tranny with the unlock code but they say nothing about the PPE doing it on the 300HP setting. I have the PPE Hot +2 in my truck right now set on level 10 (350HP) and I am looking at the Edge with Atittude sitting on my dining room table that I...
I guess what I want to know is, will the scan function of my PPE programmer work on other duramaxes even if they were not tuned with that programmer?
Phil
What should I look at for a replacement turbo that will spool up quicker. I am not looking for more PSI but would like things to take off a little faster.
Phil