thanks for your response red,yes,that was my problem,i installed a new fuel pump and it leaked oil,blamed it on the new pump,put on a second one,same problem,,,,,,pcv was the problem,,,,,,no more oil leaks,thanks
I have a 2008 kubota rtv1100. i just replaced the second mechanical pick-up fuel pump on it,and the brand new units leak crankcase oil from where the mechanical "tickler" pump runs through the housing,,,,,,,i can understand a faulty 1st one,but,now the 2nd? same issue? im now wondering if...
i have a kubota rtv 1100,i put a new fuel pump on it,and somewhere around the pump,i have an oil leak,,,,,,im not certain if the leak existed before installing the new fuel pump,i just installed a second fuel pump gasket,now,there are 2 gaskets,and i still have oil dripping off the pump,cant see...
thanks so much will,,,,,woud i see small bubbles in the transparent fuel filter WHILE ENGINE IS RUNNING? i guess the best way would be to get some transparent fuel line and put on, from the tank to the high pressure pump,and let it run,and sit overnight,to see if i have bubbles or drainback???
good morning will,,,,,i need more advice from you concerning my 3 cylinder kubotas start problem,,,,the first question is: when i look at the inline fuel filter,its completely full of fuel,except for a very small pocket at the very top of it,,,,,,,should the filter be COMPLETELY full...
will,this unit has a inline filter,,,,are you saying install the one way valve BEFORE the filter? and, where does one purchase a one way valve? it surely sounds like a great idea,in case the fuel is draining back down,,,,,,but,IF the fuel is draining back down,doesnt that mean that somewhere...
thanks,im up for trying anything at this point,i just though that in time,the air would eventually work its way out of the system once the engine was finally running,,,,,,,i need to give it a try,,,,,,thanks
no,i did not,when i finished installing the new fuel filter,i cracked the line leading from the fuel tank to the injector pump ,and used the "tickler" and pumped until i had fuel,then,tightened the line,i did not bleed the high pressure side from the high pressure pump to the injectors,i though...
thanks so much,,, im not well versed on diesel engines,let me ask you a question,,,, if someone replaces a fuel filter and or runs a unit out of fuel,after finally getting the engine running for a period of time,is it possible that there could still be air in the system? or,after running it for...
hello,i have a rtv kubota with a 3 cylinder diesel engine,,,,its driving me crazy,when i attempt to start it,i preheat the glow plugs and roll it,it then starts,but,only more a fraction of a second,then,shuts down,then,i need to crank it for a while before it starts,,,,i just installed a new...