its zero out today so it took a little to start. but it would crank over a little slower then usual. then sometimes it would be ok. what are your suggestions?
hey guys. woundering if anyone has had this froblem before. one warm day i started the truck and let it idle for a minute and went to pull it in the driveway and all of a sudden it started to misfire and crap loads of white smoke(raw fuel) started to pour out the tail pipe so i shut it off. i...
so here is the real question. who good does it work? i wanted to install one but was told it was a waste but i dont believe that at all. hows the turbo lag. are you running stock boost? im very interested. my tig welder should be here soon and i was going to fab up a really nice one.
id like to see for sure. im getting my tig welder in and then the fun begins. i want to make a cold air intake and powder coat it and a smaller intercooler cause it doesnt push much boost, just to see what happens. enyone else you know put an intercooler in theirs? i want a smaller one to keep...
another thing, with the factory junk setup i used to get alot of oil coming through my cdr valve and into my turbo and intake, now i have nothin at all and it stays nice and clean
the room between the battery and the elbow is no more then 1.5 inches. and with the longer tube you are now creating more veocity. you will not notice a difference with the added 90 deg elbow. ya its a shitty filer i have and im lookin at a 9in k&n and close off the box to keep it from the...
just installed the exhaust. i really noticed the torque and you can hear the turbo even better. when you stepped on the gas she really takes off. i cant wait to see the fuel milage difference
it is the bottom of the stock box. im using it to act as a splash guard. you can really hear the turbo with this intake and fuel economy went up as well. the pcv gromit is 42323 from canadien tire(dont know what vehicle its from) i bought a 1ft section of 3inch OD exhaust tubing to join the...