Torque spec for slave cylinder NV4500

[jrsavoie]

1994 K3500 6.5 diesel

What's the torque spec for the slave cylinder?

I have 17' lbs wrote down, is that correct?

 

[MrMarty51]

1994 K3500 6.5 diesel

What's the torque spec for the slave cylinder?

I have 17' lbs wrote down, is that correct?

What size is the bolt. Probably a metric size.
I have a chart that gives general torque specs for the various size of bolts.
Head markings help a lot too.

 

[jrsavoie]

What size is the bolt. Probably a metric size.
I have a chart that gives general torque specs for the various size of bolts.
Head markings help a lot too.

It's a stud. M8x1.5 - I think. I know it's M8. It was almost 5 hours ago I looked at it.

I'd bet it's in the manual. Would 1996 be the same? I have factory service manuals for 1996.
Might be a difference in internal and external slave.
I usually write torque specs in the maintenance book as I go.

 

[jrsavoie]

And then I found this:

97 inch pounds (11 NM)

And this
Slave Cylinder:

1988-1995---13 (18)
1996-1998---71 in.lbs. (8)

 

[jrsavoie]

What size is the bolt. Probably a metric size.
I have a chart that gives general torque specs for the various size of bolts.
Head markings help a lot too.

What do you have for M8 x 1.25?

I found it here. 13 ft lbs or 18 NM

Torque Specs

All Specs are in Foot Pounds unless specified. Newton Meter (NM) in Brackets.

www.thetruckstop.us