Ok i bought this truck and it had running issues. New pick up and lift pump later and it runs great. However lately it died on me once, just like i pulled a coil wire on a gas motor. Also every once in a while
itll fishbite. Well this morning i was warming her up and decided to open the hood and look at stuff. I decided to move the wiring around and see if i had a bad connection. The wiring and the pmd look new. po said it was new and replaced because they thought that was the problem.
The issue is when i moved the wiring at the pmd connector (its on the side of the intake with a large heat sink) it skipped and i did it again and it died. Started right up again, so i tried to move the other side of the wiring where it goes from the new (supposed) pmd to the factory wiring and it skipped again. Should i replace this wiring or maybe use some dielectric grease for the connectors? thanks for your help
itll fishbite. Well this morning i was warming her up and decided to open the hood and look at stuff. I decided to move the wiring around and see if i had a bad connection. The wiring and the pmd look new. po said it was new and replaced because they thought that was the problem.
The issue is when i moved the wiring at the pmd connector (its on the side of the intake with a large heat sink) it skipped and i did it again and it died. Started right up again, so i tried to move the other side of the wiring where it goes from the new (supposed) pmd to the factory wiring and it skipped again. Should i replace this wiring or maybe use some dielectric grease for the connectors? thanks for your help