Diagram Needed: CSA/Fast Idle

[deejaaa]

There's the hot wire from the main harness, CSA, temp sensor with 2 leads on the crossover and the fast idle solenoid. What it the correct way to get them back together? Putting it back on because of the cool weather that was here for 2 days. Never put it on after i got it running again. Made a new harness and should last a while.

 

[WarWagon]

It would be hot lead to crossover temp switch, then other side of switch to the cold advance solenoid on IP and Fast idle Solenoid. I recall the switch is "open" above 140 F.

 

[deejaaa]

thanks. pretty sure i did it that way but will double check.