1993 K2500 454 Falls flat, pops back, Low and high idle RPM.

[SnowDrift]

What would be neat is if a vehicle could go to market as designed by the designer, rather than by the accountants. Keep rust at bay and I bet we would be surprised at how infrequently a vehicle would need replaced.

 

[Will L.]

What would be neat is if a vehicle could go to market as designed by the designer, rather than by the accountants. Keep rust at bay and I bet we would be surprised at how infrequently a vehicle would need replaced.

They can. They are the special order Ferrari that is hard to get on the waiting list and start over seven figures.

 

[WarWagon]

If it's original, then it gave up the ghost after 30 years? - not too bad.

It's ~10 years old. and came off an auction site. So no telling if it was an knock-off or the real thing.

 

[udidwht]

Basic Fuel Injection Service Kit

Amazing deals on this Fuel Injection Service Kit at Harbor Freight. Quality tools & low prices.

www.harborfreight.com

When it comes to TBI the first thing to check is fuel pressure.

 

[udidwht]

Rebuilt my TBI and added a fuel pressure adapter right at the inlet. The following thread is of my TBI rebuild...

454 TBI rebuild

Going to rebuild the TBI on my 1994 GM P-30 chassis motorhome one thing I noticed with the TBI Delco rebuild kit. The base gasket is not shaped the same as the OE one. Does it matter? Also the bakelite spacer/gasket that sits under the regulator housing on the OE one is thicker than the kits...

www.gmt400.com