ZF Friedrichshafen AG-North America has updated its site since the last time I have been on it. They have organize the info all into one spot.
Click Here --> ZF Literature
jc
ZF S6-650 – Heavy Duty 6 speed manual transmission has an aluminum alloy main gear case and tail housing with the bell housing integral to the case.
The ZF S6-650 is built in both a 2 wheel drive and 4 wheel drive versions with a diesel design only.
ZF first introduced the S6-650 in 1998 on...
I made a post in the NEW! Truck Specific Clubs forum.
Check it out and give your input.
I'm just throwing it out there.
Click here to see the thread --> DTR - BoHC
jc
The pictures were taken around the Medicine Hat , Canada area after a windstorm in July.
The bales apparently weigh up to approximately 1,600lbs and some were reported to have rolled up to 5 miles.
I used a 1966 Ford 3000 Diesel with a 6' bushhog type mower made by Rollins on my 17ac when I lived in MO. The Ford is 38hp. never had a problem, just keep the blades sharp and it mowed like a finish mower if the grass was not too tall. And if it got too tall, it still mowed fine, just leaves a...
Regular glue or epoxy won't work. It needs to be a conductive epoxy.
The defroster tab fell off of the wife's Liberty last fall. I went to the local Napa and they have a "LOCTITE Defroster Tab Repair Kit." It was easy to use. Be sure you have some isopropyl alcohol or some kind of degreaser to...
NEW MEMBERS WELCOME
Here is the:driving: list so far:
ZF6 MAN
michael nelson
01duramax6spd
DunesRunner08
jc64
Cheyenne19
gearhead
Kessler Farms
deeretracks
precision37
bighawg
duramax3388
KBcoltcompany
farmer0_1
BigO-L3
DnHolland
ghitch75
As of May 28, 2008
jc
The torque specs for the eight manifold bolts is 28ft/lbs. The three bolts on rear flange is 39ft/lbs, the heat shield bolts is around 6ft/lbs or snug, and the bolt on the intermediate shaft is 39ft/lbs.
BD recomends that you allow the vehicle to go through one or two heat cycles, then...