hey gang its been awile. I finally got my taxes back and am ordering a reman pump for my truck. I have not changed an injector pump before so if anyone can give me some details on what is involved after I pull the intake that would be greatly appreciated thanks.
As you have all read, I have been having some issiues with my truck as of late. I spent some time with D last Friday troubleshooting my driveability problems. After running all the scans and killing each injector individually. Followed by a long phone call with tech support at Heath Diesel, the...
Thanks to Burning Oil for the help when I relocated my pmd. Panicked when I had to figure out how to get my resistor out of the old pmd mounted to the pump. Easy tip, remove top front screw and drive a small flat screwdriver down and break off the bottom front screw then do the same to both back...
I don't want to sound diesel stupid, but what is the OPS? It did kick a code at the same place on the way to work the last 2 day's. Light didn't stay on. I found that it doesn't have a engine to frame ground that I can find. All other grounds look good. Fuel pressure gauge is plumbed into the...
OK guys I need to know where to use my biggest hammer on my truck! I just relocated my pmd to behind the bumper with kit from Leroys Diesel (new pmd). It runs better down low but at hiway speeds it starts bucking when you level off and try to maintain a steady speed. It did this before I...
I am replacing my trashed transfer case and when we pulled the fill plug on the old one we had a massive overflow of lube. After removal and disassembly we found the front bearings and seal we trashed, also planetary was worn. I found a used unit reasonable so I am putting it in this weekend. I...
I ran into a little cash (saftey bonus) and am now looking for a good chip for my 94 6.5 F motor, 5 speed. I will be pulling my drag car (69 Chevelle SS 11.80@110mph) and I plan to buy a10-12ft overhead camper. I won't be racing the truck (I have a car for that) but I want good pulling power and...
Hey gang, I installed the new lift pump today. Easy, straightforward install but, it wouldn't work when done. I found out that the ground wire in the foctory plug had a problem. Once I grounded the pump directly to the frame it works great! The truck runs the same but now I have fuel pressure...
Just added picture and signature to my profile and wanted to see if it all comes up. I just got my new Wallbro lift pump from LEROYDIESEL.COM and I am going to install on Thursday. Can't wait to see the change in my truck!
Hi gang, new to the forum so I will tell yo about my truck. It is a 94 3/4 tonHD extended cab 4wd, 6.5TD 5 speed, F code engine. I bought it about 3 months ago. Since I got it I installed a K/N filter in the stock air box and replaced the stock muffler wth straight 3" all the way back,also...