Search results

Bearings looks mighty good from here. I’d throw in a sliver of plastugaug and see what clearance there is. I always use the permatex gasket sealer thats in the bottle with the brush on the cap. Coat the main bearing block surfaces on each side with that. Then also the very ends of the seal and...

Curious if the rear end and front differential in this truck is the same as My 2000 K3500 ? https://www.facebook.com/share/18k6HEtf47/?mibextid=wwXIfr

Stamp them rods and caps and main bearing caps, but, do it wile they still are torqued. Plastigauge is Your friend. If there is no major scoring or wear on the bearings and they ppastigauge out okay then I’d not be afraid to reuse them. Those bearings all are work hardened in and should last a...

Welcome back 57. Sad news about the coolant in the cranking case, grand news about the new truck.

Nice

4WD plus MatTracks. 😹😹😹

Solid front axle type ?

Might have to install the mechanical internals from the 92into Your 95 transmission then use the electronics thats in the 95 transmission

Its a brand new truck.

I wonder if it would be available through Rock Auto. 🤷🏼

Thank You JD for sharing that info.

Welcome to TTS JD

Yeah, I had installed 4” over Rancho shocks but now am ready to drop back down the front end, readjust the torsion bar adjustment bolts. Get it back to factory ride height. After I get the truck tires back on the floor I’ll drop the front then with the shocks still not fastened at the lower...

I bought new stock length Monroe front shock absorbers. Attached the top of the shock to the bracket. With no front wheels/tires on the truck, jack stands under the frame, the length of the shock is still at least an inch short of being able to install the bolt through the lower shock to...

Post up the part numbers, or a picture of them, never know what someone in here might have lurking in their stash. Welcome to TTS gogoburger

Welcome to the TTS Sophie. Do You currently have a pickup/truck ? We love pics too.

You might need a few more posts before an add can be placed, according to the rules of the site. Are both these engines RH rotation ? Sometimes when twin engines is run in a boat application, one engine spins clockwise and the other CCW. Welcome to TTS Dieseljet.

Ball joint installation devices, using the weight of the wehicle as a sort if a press and the hammer to help persuade it to bottom. And RH side us done except torque the lower balling, book says wait until wheel is attached and on the floor before torquing that snut. And new center carrier...

New NAPA FLEET service ball joints dont fit. Upper dont fit within the U bend and lower is too small of an OD for the bore. Damnit. I could go to oriellys and possibly get units that fit, except for, I want parts that last even if I dont. 😬🤷🏼😹😹😹 Okay, off with the drive shaft. Remind me to first...

Ball joints. Screwed up and ground the rivet heads just a little too far , then could not get them to budge to get a sight of the corcular imprint. Ended it by pulling the upper control arm. Heaven forbid, I hope to get it back on close enough to get it about four miles to the alignment shop...