Search results

Don I added to 6.2/6.5 TRL even though it is a electrical common problem all vehicles took me a while to find it as well as my searches were in this forum vs. electrical section where it was hiding out battery cables in electrical go figure :) I feel so dum looking here only :mad2:

Sticking the thread so it can be found later for reference

Sticking the thread so it can be found later for reference

No a delay apparently :) or great minds thinking alike :)

It is called a compressor surge and bad ju-ju to the vanes of compressor/wheel if you surge it hard enough and a solid 1 piece part becomes a many piece part into the intake air tract the engine was not designed to nor likes to digest

Welcome to the site

Did you check alternator is it charging properly? how far gone were batts when replacing, bad batts kill alts, also look to last maintenance item, possibly did batt terminals loosen up since the batt swap, were connections cleaned to bright shiney clean, and a corrosion inhibitor applied...

Another thought, if usings a factory style lift pump, trash in the outlet check of it could possibly let fuel drain back to the tank and maybe lose prime and your modified in tank pickup sucking air at low fuel level ?

Did you use a 6.5 sock with check valve in it or a gassser sock, it makes a difference, also does your former gasser tank have the baffle in it to keep from air being sucked into the fuel system in a turn with low level in tank sloshing over to one side?

Off top my head since we have cold snap on Gulf Coast rite now, you are having battery issues, I sent you a PM call me tomorrow clean terminals are a must, also the 2 positves left to right bank battery cable has a spacer connector between them that also has to be cleaned. if you have the...

Sealed system Al we get every bit as hot as you do in South Ms maybe even hotter at times and even towing to 18K I don't overheat, clean system, working fan clutch, stats and caps as designed are all that are required to keep the engine properly cooled.

Not ready to go there yet computers rarely go bad, you said new driver, new new or used but tested one, and new bought from where black or grey driver, mounted where ? copy/paste this and answer as much as you can...

How did you determine glows are working ?

ko/ko for timing set is not same as ko/ko for theft learn timing is a minute or so, theft learn without scan tool takes about 45 minutes to complete and is a PITA

Yo Kev "pick up da phone man" reach out & touch someone did ya lose the # :) KO/KO is as per Nobby's explanation, I'll add my experience also the hotter the better on coolant, I found out hard way if temp drops below 170F as seen by PCM/ECT not what your dash indicates there are (2) sensors...

So do 99% of the pictures of WWII workers that built the armaments that won a war, we could not even begin to attempt to fight a war today like that with current OSHA rules and ambulance chasers taking companies to court over "unsafe" working conditions, my #1 headache as a field engineer is...

Illville I moved your posts to their own thread it is easier to track a problem in it's own thread, once you find the codes post them your description is too broad to do much more than throw out a bunch of guesses.

When I had the Banks Stinger exhaust setup before going to my 4" Heath exhaust on truck now, the folks at Banks had a post turbo bung/locknut welded into the DP about 18" after the turbo in the straight leg of the DP, response for reading was not as fast as in my preturbo now but fast enough to...

Another members travails with bad gnds http://www.thetruckstop.us/forum/showthread.php?37625-Truck-won-t-start-Grounds!

Guys I've been MIA tending to wife in hospital I can't believe nobody pointed Judd to the TRL gnd thread http://www.thetruckstop.us/forum/showthread.php?17457-Grounds-what-are-they-amp-where-are-they