Search results

Wow, brake fluid can be a real science. I picked up a gallon of Brembo thought for and flush the whole system out changed out the flex hoses to braided stainless and it really tighten the system up. I'm very happy with the results. I couldn't believe how much give the rubber flex hoses had...

Truck running great!! Lots of power and lower EGT's. Also new Stealth 64 Turbo manages EGT's very well at high loads. You can feel the Merchants motor mounts, they are really solid and you get a bit more engine vibration at idle but once moving they just feel solid. The Russell braided SS brake...

What kind of additive are you using in your fuel system if any and how much are you using per tankful

I drove my truck last Friday and it is really really quiet unbelievable with all that junk gone. All I have yet to do is change the Amsoil adapter for the oil filter on the Block and put fresh hoses back to the door remote and the brakes and then I will be done with my truck hopefully for a...

I am with you Mike I got Brembo Dot 4 fluid to change it out I just didn't put it in my narrative

I mentioned changing over to a Nictane Fuel Filter adapter to replace the factory setup. Nictane The factory unit does tend to leak and looking for better reliability this was it for me. Of course I have a FASS lift pump and therefore don't need a priming unit.

I am changing out the brake lines to Russell braided SS lines and flushing gthe brake fluid. Hopefully it will give me a better feel on the brakes. I had the two rear Nitto Tera grapplers seperate on me on the way home from my last trip. I wasn't aware that the cords had seperated and could have...

Finally got to the problem, I had the video private and just made it public. You should be able to view now. Sorry about that!!

It runs no leaks

I got the y bridge kit off of eBay and it was not the cheapest but close to it and that was a mistake because a lot of things didn't line up right. As you can see in the pictures the coolant line doesn't line up right and we had to put a dimple on it so that it would fit on other than that we...

The downpipe had some issues and had to be reshaped in places the transmission dipstick tube have rubbed in hole into it and we had to weld at up and get it taken care of before I reinstalled it

I am working on the video. Got the up pipes installed and now the turbo

I will work on the video

Heat wrap came in and got the up pipes double wrapped

Hopefully this works

Well, we have a bunch of wiring to shorten and upgrade. Her is a short video on attaching the conduit to the wiring and connector. Couldn't load file says not supported I have it in 3gp or 4mp. Help!!!

I have a Fass titanium 150 lift pump installed already. That should take care of the water separation. Do you have any other suggestions Will?

Installing Merchant Automotive motor mounts

Waiting on the insulation wrap for the up pipes and then it should be close to getting done.

We got the Nictane fuel filter adapter installed for the CAT 2 micron fuel filter. Also got the right side new oversized exh. manifold installed.