Recent content by oros35

??? What's that? Apparently not..

So after about 3 more hours of searching, here’s what I’ve come up with. GM PN 88988963 List Price: $70.64 GMPartsdirect price: $36.38 No verification that this is correct although part # cross leads to this and appears to be correct. I’ve found nothing to lead me that this is not correct...

Just the connector replacement/conversion kit is $187!!!! List for it is over $250. The kit comes with 2 pigtails and a small bracket and 2 bolts. At that rate a whole new harnes would be a couple grand!

Yep, my problem is the crappy connector. Over time they tend to loose connection to the injector. You can rebend the connector tabs (ice pick method), and that usually works, and did for a while on mine. But now I can't get it to make a good connection any more. It's just upsetting to...

So long story short, I've been having problems with the #7 injector wire harness for the past 8 months. Ice picked, smashed, di-electric greased, re-icepicked time and time again. Sometimes it would last a few miles, sometimes it would last a few months. So bad I now carry a milk crate so I can...

Nice I like it!

Spray it on the undercarrage and body pannels of my vehicles to keep the winter salt from turning them into swiss cheese. Works amazingly well. And when you need to change a part, the bolts actually come loose! The rest goes to my buddy that runs Ernie's Waste Oil, they go to all the...

Which means your overloading the factory wires, it doesn't have the capacity to run all of the lights.

I found power to mine. Don't remember which wire but it works. And the reason for the small gauge wire is it only runs the relay, so don't put too much load on it or you will fry it.

Ok then does anyone have appx dimensions for the bed rails of an '05 long bed? I know most fords are about 100" x 72" I'm thinking like, A ford, about 1980-99 or so. will clamp to a 94-2002 Dodge, but hangs over a couple inches, that's fine with me.

Drivers side Wheel bearing. It was pretty bad. Plus my calipers were froze so it destroyed the rotors and pads.

Looking for a cheap cap for my '05 Chevy with an 8 foot bed. I can find Caps that were on Fords everywhere but not too many that say Chevy. What caps will fit? I'm not worried about looks, just function. I'll only be using it every once in a while as I normally tow a goosekneck.

Hey glad you came over!

Pull off the oil pan and tap it out from underneath. They usually stick down into the pan a bit.

Also after driving it today, I only notice it at about 40mph and up. Flat smooth roads I notice it the most. I'll have to jack it up and check the bearings tomorrow.