I've never purchased Bio Diesel before unless the Station is blending it and not notifying the Consumer on the Pump, didn't think about stuff growing in my Fuel BUT I do run a Quart of Power Service Cetane Boost in every fill up so I hope that would take care of algae or anything else living in...
The "sock" was brand new with the fuel pick up assembly and it has been in the tank since '08, never ever purchased Bio Diesel before, usually comes from United Dairy Farmers which is a Cincinnati based food/fuel store which sell Mobil Fuels, I buy a lot of Gas there for everything I own with no...
Bought the Truck used in 2000, New IP in '06 along with a remote PMD (under front bumper), ran fine until '08 and then it started quitting as the fuel level got low, wound up installing New Tank (as the lining was deteriorating) along with Fuel Gauge Pick Up & New Sock & Lift Pump with a Gauge...
Bought a 94 GMC Jimmy S15 and the Blower Motor only works on Low/Medium, not High. ALL Fuses good as is the Fusible Link, NEW Resistor/Relay/Motor but NOT Switch, any ideas?
Thanks for the reply, I have done the sequence without using a Scan Tool like the Link you provided said to do without any success, I wonder if any Scan Tool will work as a friend has a Snap On Scan Tool that will work with OBD 1?
Has anyone ever reprogrammed a door remote? I bought a 94' GMC S15 Jimmy with power locks and it came with a remote that won't work even though it has new batteries. If the remote itself is bad can I reprogram a factory remote from my 94' Camaro which uses different remotes that came with the...
6 PSI at the water drain, I am pretty sure the replacement Sending Unit had a sock on it but can't remember since it was replaced in 2008,fuel looks and smells like it always does, I will check for clogged screens at the lift pump. Thanks for the reply!
I purchased my truck in 2000, it is all Factory except for the following, IP was replaced back in 2005, the lift pump back in 2008 (with a fuel pressure gauge mounted under the hood which shows 6 psi at idle) the tank/sending unit/fuel lines and the PMD (with a number 9 resistor) on a Heat Sink...
I agree with the tweaking here and there but still a lot easier than trying to make that 90 degree bend between the leaf spring and the backing plate, definitely worth the $35.00 + shipping