• Welcome to The Truck Stop! We see you haven't REGISTERED yet.

    Your truck knowledge is missing!
    • Registration is FREE , all we need is your birthday and email. (We don't share ANY data with ANYONE)
    • We have tons of knowledge here for your diesel truck!
    • Post your own topics and reply to existing threads to help others out!
    • NO ADS! The site is fully functional and ad free!
    CLICK HERE TO REGISTER!

    Problems registering? Click here to contact us!

    Already registered, but need a PASSWORD RESET? CLICK HERE TO RESET YOUR PASSWORD!

Recent content by Jess_sr

  1. J

    Tranny not shifting into OD HELP!

    My 93 and the kids 95 only have a LU delay for temp. Then again with the prom being replaced on the 95 who knows what was writen into the program.
  2. J

    My 6.5 is sputtering

    Did you change the fuel filter?
  3. J

    Glow Plug Controller Function

    Pcm controls glow plug time based on CTS, Air intake sensor and Battery voltage.
  4. J

    1st Dead Dipaco/DTech PMD ??

    Don't think so. Paid full price and was labled dtech on it.
  5. J

    1st Dead Dipaco/DTech PMD ??

    We just had a Dtech PMD fail on my sons truck {bumper mounted} when it was installed a little less then a year ago. Not happy about it to say the least!:mad2:
  6. J

    How do you get the glovebox out?

    Push the connector in, then press the tab to release and pull while still holding the release tab down. Sometimes this helps;)
  7. J

    oil leak comeing off of power steering drive shaft

    Just did one today. took about 3 hours. Got the seal kit from the dealer.
  8. J

    Fishing trip not without issues...

    An after thought. :thinkerg: Run a temp. power wire to your turbo control from another source.
  9. J

    Fishing trip not without issues...

    Seems odd that a soleniod would blow a fuse that size. I'd be looking for a rub through wire or the heater circuit problem that would draw more current.
  10. J

    How to remove the front drive shaft from a NP 246 transfer case.

    Doesn't matter. Your choice.:)
  11. J

    How to remove the front drive shaft from a NP 246 transfer case.

    Cut the clamp then use a wire tie to replace it after you reassemble it.
  12. J

    leaking power steering fluid by master brake cylider

    Just unbolt the master cly and move it aside. No need to open the brake fluid system just to replace the booster
  13. J

    leaking power steering fluid by master brake cylider

    Power assist for the brakes use a Hydro boost set up powered by the power steering pump. Sounds like you need to replace your Hydro boost Unit.
  14. J

    Front blower question

    Thats from GM. Save the image to your PC then enlarge it with your picture software.
  15. J

    Front blower question

    Hope this helps
See more
Back
Top