Recent content by CBR consulting

Valve body was done at DHD in Michigan. I was more talking about the mounting bolts.

Could valve body tourquing have anything to do with these codes? I will be pulling it out tomorrow as the weather isn’t cooperating today

I tried another brand new solenoid I had. Goes nicely into reverse can back down the driveway When I go to drive and start going forward lights come back on Code p0871 P0872 E stuck open E stuck closed

How do I remove the e valve does the valve body have to be dropped out of place again

So I did this test. Watched the scanner and when grounded out it turn on which is closed . I will pull the pan tomorrow and do the Same test. Am I only looking a E valve then I ordered two new solenoid just in case to have for tomorrow Definitely feel I’m on the home stretch with this...

Unplugged the engine side trans plugged Turned the multi meter to ohms Used one prob on E. and other on ground No resistance nothing out of the meter Also checked the hole circuit from TCM red connector pin 3 So I’m thinking that means it’s not shorted to ground ? Should I order new...

Codes were cleared before test was done Could you explain the best way to test for short to ground. Sorry for the the explaining I’m having you do

Thanks for that Upon following the procedure When in Drive. I have C-On d-On. E-On

so I currently. Plugged everything all back in And what do you know. No idea what I did but have the hole harness opened up and moved everything around the last few days It goes into reverse nice and gentle. Goes into drive gentle nice and gentle If I tourque up a little bit in drive it...

How would I check this Rockabillyrat. Is there a way I can bypass this NSBU switch to see if I get reverse I appreciate everyone’s help with this truck.

Yea we are talking about the NSBU switch I just included the pictures of the ignition switch as rocky said it gets power from the yellow wire on the ignition I have 12 volts cranking on line 12 at the NSBU plug. I have constant 12volts when ignition is turned on in pin 11. I also checks...

This is the ignition switch I put in

Probed pin 7 as ground and pin 11. Good solid 12 Volts Probed 7 as ground and pin 12 for power I got 9 volts Did it a second and third time and now reading nothing Used frame as ground aswell and ground direct from battery. Tomorrow I’m going to open up the harness from NSBU to top of...

Looking for the location of we’re pin 12 goes. I should have constant 12 volts here with the ignition on correct ?

I don’t have the original. Baby rockabillyrat. Know where the grounds 1,5 from gray. TCM go to. Or what other components use those grounds I can follow them both to the splice pack. From there I don’t know want to check every possible place that these two circuits go Or what else...