Recent content by CBCS

I also noticed my defrost when set to blow hot air blows cold air.

I'm having the same problem but with the auto temp control. It blows cold air for a while then its like the heater kicks on if i turn off the truck and turn it back on it works again for a while. It only does it on the drivers side the passenger side works fine all the time. The colder i have...

Im in

Yeah, just happeded to me on the side of I80 in nowhere iowa, only the #7 cylinder went, sounded like a really crappy powerstroke. They only replaced the #7 cylinder connecter but gave me the connector for the #2 cylinder should i replace it now? and how hard is it to replace those connectors...

What does the truck do when these connecters go bad?

I have noticed that his truck smokes quite a bit under hard acceleration even stock, would that have anything to do with this code or another problem. I have an identical truck and my doesnt smoke near as much even with my edge turned up. Thanks for the feedback.

What exactly does the P 1621 code mean? Its my dads truck and we are about to go on a 3000 mile round trip with it, do you think it should be fixed before we go or will it be fine for awhile? There was no check engine light on and I only noticed it when i was taking his programer off and...

I got a P 1621 code today, anyone have an idea what it is?

Then to solve the egr problems, would you guys just recommend blocking it off and putting the stick in there so it wont throw codes anymore? It is out of warranty.

I just had my codes checked and i had 3 egr codes and a P1093. My truck went into limp mode a few times this weekend pulling a trailer. Runs fine with no trailer. Will the egr codes cause it to go into limp mode or only the P1093. I have a race valve in, i need to change the fuel filter and...

I have a race valve in mine, so there should be nothing in the bottle correct?

I was wondering the same thing.

Yeah i think ill just put the race valve in and be done with it. Have the dealer update the computer for the rough idle bulletin and should be good to go.

I took it to the dealer and they said that the fuel pressure was dropping under load. The relief valve was opening too soon not giving the rail enough pressure and causing it to go into limp mode. They wanted to change the relief valve and reprogram the computer. They also said there were 7...

Does anyone know where i can get an aftermarket fuel pressure regulator? Dealer wants 300 for the part and another 250 to put it on. Or will a PPE shim kit solve my problems?