• Welcome to The Truck Stop! We see you haven't REGISTERED yet.

    Your truck knowledge is missing!
    • Registration is FREE , all we need is your birthday and email. (We don't share ANY data with ANYONE)
    • We have tons of knowledge here for your diesel truck!
    • Post your own topics and reply to existing threads to help others out!
    • NO ADS! The site is fully functional and ad free!
    CLICK HERE TO REGISTER!

    Problems registering? Click here to contact us!

    Already registered, but need a PASSWORD RESET? CLICK HERE TO RESET YOUR PASSWORD!

Recent content by aussie burb

  1. A

    6.5l turbo no start

  2. A

    6.5l turbo no start

    i remember you mentioning that. The problem i have is that parts are not avaible my side of the country.I have to get parts from sydney or melbourne {5000kms} or from the us.Very annoying i wasted 1 1/2 weeks looking for the problem
  3. A

    6.5l turbo no start

    i agree was already thinking about doing what you suggest. best part is On the road again..!!!!!
  4. A

    6.5l turbo no start

    guys problem solved after replacing 3pmd and 1 ext harness we have a go and normal start no smoke normal revs i might get sued for this but amazon is on my shit list big time.guys all your replys and suggestions to solve this problem was really gratefully recieved thank you big time
  5. A

    6.5l turbo no start

    `im going to right now
  6. A

    6.5l turbo no start

    when i start the engine cold i always wait for the glow plugs to go through the cycle.do any of you guys know what the volteges etc should be at the connecter that goes into the PMD . mine shows A green 0 volts B red 0 volts C black ground 001omhs D pink 12v E red 5v F ground to ip checked...
  7. A

    6.5l turbo no start

    Will check tomorrow thks
  8. A

    6.5l turbo no start

    the problem here is there is no corner parts shop for these engines.it takes 2 weeks to get parts from the us
  9. A

    6.5l turbo no start

    gday thanks for your reply.the little bit off start gas i used was enough to start motor and run by itself. as the motor warmed up the white (diesel smelling) smoke disappeared.when i pushed acelerater to floor very slight increase in revs but heaps of white smoke. motor idleing normally 700rpm...
  10. A

    6.5l turbo no start

    We have a start of sorts.i used small amount of starting gas and it running. Still huge clouds of white smoke and no revs.decided to let it idle and warm up as the engine warmed the white smoke went away.as soon as pushed gas pedal down slight increase in revs but lots of white smoke again would...
  11. A

    6.5l turbo no start

    gday mate there was some damege to the connecter ihave fixed that.Would the pins still make good contact?the ground was cleaned and refitted.it was starting and running fine except it was doing the pmd thing stopping and then having to wait before it would start again' thanks for your reply
  12. A

    6.5l turbo no start

    i have changed the pmd and tried origonal wiring harness again and yes i used a heat sink
  13. A

    6.5l turbo no start

    replacrd and relocated pmd and now very hard to start if it starts at all.lots of white smoke and no revs .help!!!!!
  14. A

    introduction

    try outback opal hunters its a good show
  15. A

    introduction

    gday mate thanks for your reply.ill will post all details asap
See more
Back
Top