So over the years quite a few people have tossed the idea around of direct injecting a 6.5 via c/r injectors adapted to fit down to were the cups reside. This has yet to physically manifest its self due to high cost, complexity, and the need for a dmax or aftermarket pcm & whole-lot-of-tunning...
Hello everyone,
Just wanted to give a big thumbs-up for Peninsular Engines in MI!
My last posts here were about a military pullout 6500 Optimizer engine that I purchased from a vendor, which two were delivered in a poor state of health. (Advertised as low milage, good running & “tested”...
Long story short; some of you may remember my dealings with Ted’s Trucks and the two water damaged long blocks I received from them. :BDH:
I finally got a set of 0.030 over pistons, the heads have been done for awhile. I tore down the block last night and found some unusual bearing ware...
Hi Guy's,
Just to clarify, yes I did just join the "Truck Stop" today. And yes, I did join to share my bad 6.5 purchase experience with Teds Trucks!
A little background info:
I purchased one of Teds 6.5's back in April 2011, when I purchased it I told Margaret that I intended to pull...