Search results

On Ebay. It takes two to three weeks from the US.

Just want to turn back on this one too if any others can learn from the troubleshooting. Finally bought a remanufactured viper-motor and now vipers are running as smooth as new. It must have been inside the motor that someting was worned, making the vipers to shake and stop. regards Max

Finally my mechanic got things sorted out. There were two things wrong. In the inner fender om the right side, a positive wire to the turn signal was rubbing aginst some metal. And the electric plug for trailer light was erroded on the back side, making possible problems too. Thank for your help

Hi gyes Finally giving up on my 1995 Silverado 1500 Z 71 6.5. I think of getting a replacement thats a little younger and most important, more reliably. Too many electronic faults on the Chevy, too short life time for new parts, too hard to cure the fish biting, and just too many...

Thank you for advice. Four way flashers blows the fuse right after pressing the switch. I disconnected all bulbs and started checking for power at the connections while the truck was set to flash to the right. After one minut a light fog was coming up from the dash and things were warming up...

I lost the right turn signals. Only the rear will flash at half power. The other ones got no electric power to them. Inside: --On the dash the right turn indicator does not light up --The relay will tick like normal --The voltage guage will move into the red zone at every click --It will...

The PMD is about 1,5 years old but does not have many miles on it. Allright, I will order a spare to carry with me in the glovebox then to be ready. Thank you

Folks, my truck started to disengage the cruise by it self. It warys how long it will stay on. Some times only 30 sec, other times it will stay on until I disengage it myself. Is it an early warning of my PMD going bad ? SES codes were only about the EGR the last time I checked. Another...

Troubleshooting a ABS-problem on my Silverado 1996 4w4 and wondering if the sensors can switch sides ? I know that the right one is good, but a salesgye think that he might send me a wrong one for the left side, that maybe causing problems. (ABS kicks in at low speed on the left wheel) but...

Hi Truck Stop Recently had my Silverado at the mechanic because the ABS light was on. He changed a bad sensor at the right front to fix it. But now the ABS is strange. When stopping, the last 5 feets, the ABS kicks in at the left front wheel. Buzzing, making the pedal hard to press and...

Hi gyes My Silverado throws the codes 84 and 99. Both ones is supposed to be about the accelerator. Truck runs fine, have not noticed any thing odd. Is it an early warning that I have to replace some thing ? It throws a bunch of codes regarding the EGR too 32,33 and 36 Regards, Max

Hi again. I installed a new pulse board, but the problem is still the same. Vipers vil run at the two constant speeds, but when choosing any interval, vipers wil stop midways, and maybe after a while slowly shake back to start position. Shall I look for a new motor too do you think ? Maybe...

Thank you for the help. I talked to them again and they claim that they allready tryed to jump the switch, but still no alectricity was supplyed to the compressor. Any other clues of where to troubleshoot before making a bypass wire ;0) //Regards

Hi gyes What could be wrong with my Silverado 6,5 4x4 1995 truck when the gears are scratching (or brushing teeths) when I try to mowe the reduction lever from the High group to the Low group. ? It is impossible unless I shut the engine down. Is it an easy fix ? I dont think my...

Hi gyes I had my A/C system filled up to see if it worked. (Truck has been sitting fot 1,5 years before I bought it last summer. Don`t know how many years ago A/C worked the last time.) He says no leaks, the switch works, and the relay is clicking, but still the compressor does not get any...

Hi, Yes I am sure the motor needs the grease. Mine looked the same, and the motor it self always ran good. Like mentioned above, my fault came from some sort of loose connection in the connection-plug I ended up getting a used unit with a better connection, and the vipers started working...

Hey gyes My wipers are shaking in the intervals, and some times stopping midways. They are only running smooth in one interval and in the normal two continous speeds. No sounds from the connection bars and everything is greased up. Would you suggest bying a new print only, og will I be...

Thanks gyes She´s only giving codes for the goofy EGR-system and no one for the brakes. The other day when the pedal did the same trick again, it became hard like a rock, and would not stop the truck, before I released the pedal and pressed once again. Any other clues ? Orange ABS light...

I promised some pictures of her with the new rims. Here goes.

OK gyes. I ended up bying 285/75 16 tires for her, and I would say that you dont want to go bigger unless you want to lift the body. The wind channel needed to be cut a bit, so like the lower corners of the fender. On the rear of the wheel wells the mud flap needed to dissapear, and thats...