Hi, i have to chanfe my crankshaft position sensor, however whe trying to take it out it hits on the power steering pump, is there any easy way to loosen the pump just to jiggle it a bit? If only it would be about 2 millimeters shorter it would slide right out. If not there is a way to loosen it...
My 6.5td 97 runs perfectly fine until about 2000rpm and above, at this point it starts hiccuping and goes into limp mode. Usually the code p0251 and p0355 comes. I have gone over all grounds, changed pmd and relocated, and done so much more i cant even remeber. Anyone have som good ideas for...