Search results

thanks everyone for the replies,i will go ahead and measure the ring endgap,there doesnt seem to be any cracking in the main web and the heads look good too other than a little carbon build up,thats a great idea on the brass cone to clean things up,im going to pick one up today, Thanks everyone!

Hi, i got a 86 6.2l engine out of a military blazer recently that ran good , saw with my own eyes it fire up and run, so i was going to regasket it and throw it in my truck, but after i got the heads off i notices quite a bit of carbon built up on the pistons and i notices i could shimmy them...

Its a th400, my truck was a gaser and i did the swap from a k20, prolly shoulda said that, it did sit for 2 years, i only drained the fluid and added new, had a drain plug on the pan, aftermarket,i dissconected the kickdown and still the same will cruze in third fine but any pressure such as a...

I have an 85 k10 with a 6.2l and th400, the issue im haveing is when the trucks in third and i mash the pedal down or even just medium acceleration the engine will rev but wont go faster, could barely hold 60 pulling a trailer up hill, been doing this for about 1000 miles now, 1st and 2nd work...

I just turboed my 6.2 in my 84 k10 and had to remove the A/c heater box because it runs into the down pipe, i have the non ac setup but the holes in the firewall are no where close ,i thought iv red somewhere that you can adapt a s10 heater box in its place somehow but cannot find a thread on...

where could i get the oil feed line adapter fitting from , in the pic above, Thank you

hi im building a 6.2/6.5 hybrid for my k10 and was wondering what downpipe i could use for the turbo, it has a 3in v band on it, is the stock downpipe ok or is there another avaliable, also where can i find an oil feed line to run it because i dont have one being originaly a non turbo and i...

that is fine for me as i just use this to tow my jeep around, not much offroading, do you remember what pipe clamps on the hx40wii to fit in the spot you sais, Thanks :)

Hi , im new to this site but visit it regularly for tips and hints, im having trouble finding a downpipe for my truck, ive been doing a swap and this is the last piece needed and was wondering if anyone knew of a downpipe that would work for my setup, i have an 84 k10 with a 6.2l bottom and 6.5l...