Search results

How did you balance the flywheel?

I agree sctrailrider should get some funds! Good idea to run a baseline next to yours, hopefully someone is close to you.

Look for medium duty diesel trucks. I know the 8.3 cummins and cat 3126 have nice turbos on them in our size range. 400 for the hx40, is it ready to go?

This is the best use of a gm turbo i've see yet:hihi:

Tires are under 100 each for mil surplus Watch out for trailer tires as lots of them sit flat

they have 7 inches of backspacing Need spacers or dually hubs to get correct fit. Hard to find 16.5 tires under 37 " so you'll need lift

guessing you opened up the precups a lot?

Its always good to know people Sounds like he gets around too What year thermostat housing is that in the picture?

I am keeping the ones under my truck shorter and above the bottom frame rail, so i can build a shield for them easily.

and...

Thanks for the part numbers i was getting my 2 and 6 microns mixed up. All my filters are 1-14 thread. One before the lp, and one in the engine bay. Have another filter head on order that will go in the engine bay too. thinking 20-10-2, or 20-6-2, but ideally 20-10-6-2.(all micron ratings)...

Ah so it has not gotten "the works" yet Let me know how the turbo does with less fuel

What size exhaust housing are you going with? And the balanced motor will be nice:)

Nice, good to know it is up. What happened to the ip? How you gunna make up the lost power

Can someone transfer this to the alt fuels section for more discussion? I have irs documents, that say for personal use under 400 gallons requires no tax payment. Massachusetts has a fuel permit, optional for personal use. Have to report fuel use monthly, not sure if you have to pay though the...

Save those rods Guess you've got to try harder to blow this next motor..

Im going to burn atf soon, :WTF: Dirty injectors are easy to clean Free fuel that is thin in cold temps is better.:thumbsup:

PO is an idiot If the clutch is new and the flywheel is ruined, they left off the brace and then chewed the starter/flywheel It being manual if you can bump the engine over you might be able to find a good spot. Get ready to split the trans/engine apart. And get that bracket!!

Good to hear its coming back together. You going with the same set up?

Its been a week:hihi: