Search results

Hi gyes Finally giving up on my 1995 Silverado 1500 Z 71 6.5. I think of getting a replacement thats a little younger and most important, more reliably. Too many electronic faults on the Chevy, too short life time for new parts, too hard to cure the fish biting, and just too many...

I lost the right turn signals. Only the rear will flash at half power. The other ones got no electric power to them. Inside: --On the dash the right turn indicator does not light up --The relay will tick like normal --The voltage guage will move into the red zone at every click --It will...

Folks, my truck started to disengage the cruise by it self. It warys how long it will stay on. Some times only 30 sec, other times it will stay on until I disengage it myself. Is it an early warning of my PMD going bad ? SES codes were only about the EGR the last time I checked. Another...

Troubleshooting a ABS-problem on my Silverado 1996 4w4 and wondering if the sensors can switch sides ? I know that the right one is good, but a salesgye think that he might send me a wrong one for the left side, that maybe causing problems. (ABS kicks in at low speed on the left wheel) but...

Hi Truck Stop Recently had my Silverado at the mechanic because the ABS light was on. He changed a bad sensor at the right front to fix it. But now the ABS is strange. When stopping, the last 5 feets, the ABS kicks in at the left front wheel. Buzzing, making the pedal hard to press and...

Hi gyes My Silverado throws the codes 84 and 99. Both ones is supposed to be about the accelerator. Truck runs fine, have not noticed any thing odd. Is it an early warning that I have to replace some thing ? It throws a bunch of codes regarding the EGR too 32,33 and 36 Regards, Max

Hi gyes What could be wrong with my Silverado 6,5 4x4 1995 truck when the gears are scratching (or brushing teeths) when I try to mowe the reduction lever from the High group to the Low group. ? It is impossible unless I shut the engine down. Is it an easy fix ? I dont think my...

Hi gyes I had my A/C system filled up to see if it worked. (Truck has been sitting fot 1,5 years before I bought it last summer. Don`t know how many years ago A/C worked the last time.) He says no leaks, the switch works, and the relay is clicking, but still the compressor does not get any...

Hey gyes My wipers are shaking in the intervals, and some times stopping midways. They are only running smooth in one interval and in the normal two continous speeds. No sounds from the connection bars and everything is greased up. Would you suggest bying a new print only, og will I be...

Hi gyes On my Silverado, 1995, the ABS light has started to come on at some point every day, but disapear again after some minutes. Brakes are working fine, but some times the pedal will feel hard and make a surring noise. Like it will not sink as deep as it use to, and kind of vibrates and...

Hi gyes Planning to put on 33x12,5 tires on the truck. She´s currently on standard 265x75. Will I need to order the rims with a certain back spacing or will a standard 8 in wide, 15 in rim fit and leave clearence in the wheel well ? Looking forward to your replies, and to get some decent...

Hi again 6,5 experts :hello: More 6,5 questions from a confused dane. Looked at my PMD-plug today and realized that it did not have that tiny green calibration resistor plate in the buttom of the plug, that some says needs to be there. It´s a black Stanadyne PMD dated 2007 Truck runs and...

Hi :hello: Had my intake manifold and turbo off to change injectors, and the intake is nasty inside from oil probably from the breathing hose. Wonder if I can just let the breath away in a hose under the truck, and out in the back, instead of having the engine to eat oily air ? It´s not...

From reading posts in here I understand that the headlight relay is to be found on the grey under dash panel to the left of the brake pedal.:thumbsup: Well.. My truck does not have one, :hihi: only a retrofitted drivers light relay is found dangling down there, getting its power-signal from...

The new fuel filter element I installed this fall has started leaking around the plastic nut/spinner on the top of the FFM. Got it tightend down until plastic meets the metal of the FFM, but it still leaks. Is it common for a new filter element with a new o-ring to start leaking this early...

Gyes, just realized that my truck has an block heater, but the cord has the american plug telling me that it is 120 volt. Guess i better not plug it to my danish 220 voltage systems on the farm with out an power converter, or does the system has one built in maybe ? Getting cold ;) Thanks

Bought a new GP relay but the pins are different from the old one. The old one has three pins (in the outlets number three, four and five, counting from drivers side.) (Dont know the age of it) The new one has four pins in the outlets one, two, three, four. Shapes of the new one tells...

When I release the throttle, and press it down again, a clunk is sounding from somewhere in the driveline. Sounds like comming from the middle of the truck or somewhere behind that. It feels like there is some sort of slack too. This thing is getting more and more. Truck has 163 k on it, and I...

Hi gyes My voltage guage usually points near the red mark at 9-10 volts. Batteries cranks the starter quickly and it does not seem to lack any electric power. Some times driving, it will raise to about 12 V, but never above, and the next minut point at 9 again. My brother checked the...

Whoops, while connecting switches for extra lights, i accidently made a short. Took power to run the light in the switch from the light grey electric panel under the dash, in front of the parking brake release. Got the cables connected wrong and it sounded like a fuse burned (Click) and no...