Search results

Yea they do it here as well But they charge for half pint of paint plus the cab fee It comes out to be 40 ish 75 dollars depending on color code.

Will I think you are just jealous our vans don’t use alarm, we use pod locks and boobytraps

Yes any enamel / solvent paint will work

Lol hahaha

I will give you a little dirty experienced painters trick secret that I did on this van. this van was in bad shape, it needed full paint job, but it’s a work van, the paint code on this van is very expensive, 190 dollar a qt, it needed over 1.5 gallons to finish the job after primer. so I went...

It all depends on the condition of existing paint, painters techniques, low pressure or high pressure, silver based paints have low coverage compared to solid paints such as red or yellow or black. Good prep and mostly matching existing color, you can paint with 2qts it also depends if you are...

some local grow / hydroponics stores know people who sell there equipment Ask them too

Look up in Craig’s list or offer-app definitely get an LED light.

Yes if you connect the hand held back to TCU it will show all your settings, Don’t be afraid to click on them to view it won’t change the setting unless you press up and down arrow.

Yeah I would definitely use the factory TPS sensor

Make sure that shift points are not set to aggressive shift

There are two + 12v inputs for TCU One is connected to directly to the battery and the second one is for keyed 12v power at any given time there is power in the TCU When you turn off the key yes the hand held screen stays on because there is still power in the TCU

Go back to settings menu and start as a new tune See if you can change that You have to calibrate your TPS sensor again

Mine is set at 1800

You should be able to go as low as 1600 RPM

You have to contact both of the wires from the sensor to ez TCU RPM input, EZ TCU needs square length RPM signal to work and that sensor on the back of the engine provides that if you connect both ends

only reason it goes in default mode is if the main positive and negative are not directly connected to battery at the end you have to turn off the key and give 10 seconds to save all the settings

How do you know it’s bad Did you connect both ends of the sensor wire to Ez TCU RPM input side ?

also make sure on the hand held programer to put maximum shifting RPM to 1800