Search results

I flowed them on my heads . We both thought the dual plane would be better but that was not the case . These were both NA manifolds .

No need , open plenum flows 198 and the dual plane about 20 CFM less .

Sounds like the conv is locking . Just like driving a stick and forgetting to push the clutch in at a stop light . Have you checked the brake light switch for adjustment ?

Ever thought about doing all the rubber brake hoses ? Changed mine on my 91 , made a big difference .

I'd put 1 oz in each part .

Why don't you start another thread on just the steering issues ?

Maybe with just RPM and VSS sensors working , that's enough info for the ECM to operate .

300 psi is too low for a diesel compression tester . Should be closer to 400 or more for a good engine .

I find it odd that all the sensors are dead . Does the DIC have any pressures showing ? Have you put it on a scanner ?

That's why you have a problem bleeding the air . Take the glow plugs out , leave the lines tight and crank it over with your foot on the floor . It's the rpms that bleed the air . I did a 95 like WW did except all the glows were out . A lot of misting . He basically had the entire fuel system...

Rock Auto lists both 350 and 400 for the diesel .

Yes

Am I the only one not seeing any bolts in the gear ? Not seeing any holes either like the pump has moved or is seized ?

Did you degree the cam and change it's timing ?

I would suggest waiting until you change all the glow plugs . Pull them all out and then crank the engine over . This gives you a much faster cranking speed which helps to bleed the fuel system quicker . You can sit in the truck and see the misting when cranking , it is very obvious . Also ...

Yes , that is the oil pump drive with the sensor on top . The CK model had vacuum for the AC only . This is the earlier model , 81 to 87 . I'm trying to use a serp belt and Banks so a lot is going on up front .

Yes

That's OK . Just looking for some info . There was someone , 65GMCTD I think , that had posted about sensors . They will bolt in but one had a square wave output and that could not be swapped because of the output . I have a few of the California vac pumps with the sensor on top as I want to use...

Will , any more info on the 2 wire cps ?

Yep , my thinking too . Not really worried about other points of view as I've heard this over and over again . I have my thoughts and that's why I had my heads ported and picked up the Crane regrind . Could I be wrong ? Sure but it's my money and time and I might just learn something . I think...