Search results

Might not fit in the truck without some firewall mods. Up pipes are 2 3/8 stainless .

The turbo housing is .82 ar. I think it's to small. But I did install a big 10 blade turbine with 64 mm exducer. Yea I'm not real impressed with the stock bellows either. They are so thin ! I have run big and small precups ,and for me, smoke the same.

Yea,a .330 pump would be fun. I'm not worried about the little .290 I will get right eventually.

Precups are triple square,and the head are stock 6.2 . They don't even have valve seals. It will be fine,plus the valve stems will get lubed better.

As far as the pump,the .290 should be fine. It usually takes me a couple tries on on each pump I build. Plunger size is not near as important as all the other mods and adjustments. Basically what I'm saying is , a stock pump with only big plungers ,will not be as good as a fully built smaller pump.

The turbo is a bit high,but the truck has a 2 inch cowl hood. I have torqued head studs at 130 or 135 ft lbs before. At 150 ft lbs the deck starts pulling up around each stud. We used a new timing chain ,that was probably made in the 90's ,and it fit very tight. The nozzles are china 311's...

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F183762053061 This should be the link for the turbo flange.

Got the turbo mounted,need to work on the up pipes next.

Yea,its best to have a modified pump,everthing has to work together. Wish I would have bench tested this one,its not doing what it should.

For a better runing engine.

Had it runing on the stand. Engine seems good,but inj pump leaks at the advance plug. Have the injectors set at 3500 psi. Ip is not putting out as much fuel as it should either. I think the advance is not working, prob because of the leak.

Heads are on, ARP studs torqued to 130 ft lbs with moly lube. Used high temp silicone on the block threads.

You probably can get it at a John Deere dealer. This was just VHT daytona green.

Planing on 25 psi boost with a 3 inch intercooler. Should run pretty good. Just need to put it all together.

It should be a little less than 18-1.

Cometic .056 thick 5 layer gaskets.

Cometic 5 layer gaskets should be here soon.