Search results

Does this only work with a gasser?

Flushed the heck out of it without the thermostat until the water ran clean. The guy i buy parts from loaned me the tool he has. Nicer version of what I linked.

It's not that I need to dislodge crud but more that there is still rusty water running around in the system. After the test run, it was several months before it fired up so the water sat in the passages for that long period of time. I didn't realize how nasty it was until I changed the...

Has anyone used one of these kits...

Welcome to the site. I can't offer any advice but wanted to welcome you.

I have one of those kits sitting around if someone had a use for it.

The arrows indicate the new cord location. Routed under the brake lines. It took quite a while to get the factory clamps loose and ended up needing a thin wrench due to one spinning but all in all it went ok.

It turns out that it was the cord which had failed. I found an OEM part from a place in New York after I was given the part number by our local dealer for just another obsolete part.

Sounds like there is a PCV update kit someone came up with to solve some of the common issues.

Good information. Thank you. Dorman valve cover will disappear soon. 126k on the ticker. Not sure if that is considered high mileage or not.

Fluid Film if I use anything on electrical on a vehicle

I plugged into an outlet and can't get 120v anywhere on the end of the cord at the heater. I tried probes in all 3 holes in about every combination I could so I'm guessing the wire is broken somewhere. Does anyone have the part number for the OEM cord?

...rub it in, Will... I know it snowed there at least once. I heard about the snow at the bottom of the Luxor.

I've no need for anything above the OEM 600w. Normally if it's cold enough to have a need for that kind of heat, there will be salt on the roads.

What is the recommended block heater for our trucks? OEM would be just fine for me. I see Unique Diesel carries them. I did find a Katz 11612 also. Theirs is short and stubby in comparison to the others I see for sale which look longer. I don't know what the factory one looked like and I...

Let us know how the bracket works out that is supposed to mount the air box to the wheel well.

Agreed. It wouldn't bother me on a cast iron intake but I'm not yanking on aluminum like that. We actually have a similar plate and debated on it but at the end of the day both the old and new engine were lifted and lowered using the steel hooks attached to the heads from the factory.

While looking for Chevy Cruze cars recently, there were a couple common themes. Valve cover gasket replacement and turbo cooling and oil lines. Some dealers just replace the parts when they get one before selling. For those familiar with these cars, is it best to just replace the in and out...

Make offer. Boxed and ready to ship out.

Make offer.