• Welcome to The Truck Stop! We see you haven't REGISTERED yet.

    Your truck knowledge is missing!
    • Registration is FREE , all we need is your birthday and email. (We don't share ANY data with ANYONE)
    • We have tons of knowledge here for your diesel truck!
    • Post your own topics and reply to existing threads to help others out!
    • NO ADS! The site is fully functional and ad free!
    CLICK HERE TO REGISTER!

    Problems registering? Click here to contact us!

    Already registered, but need a PASSWORD RESET? CLICK HERE TO RESET YOUR PASSWORD!

Search results

  1. C

    Running boards

    I have a set of aluminum running from my old gasser, there is some corrosion on the part that bolts to the body. Are they still OK to install or will it promote rust on the truck? There is also a rust mark on the boards, any ideas on cleaning it off? Thanks
  2. C

    No start

    Can the PMD just quit or is it more likely to be flaky before a failure? It was very cold here when the truck was started and left 5minutes to warm up and stalled, seemed possible that the fuel gelled (that cold) since then the temp has come up and close to freezing and it just turns over...
  3. C

    Instructions

    Anyone have manufacturer install instructions for: Silver stirrup full length running boards and Lund lighted visor?
  4. C

    code reader scanner

    Can get a reader that displays some "Live" data such as EGT, MAP, and reads codes, but not volts or coolant temp,is it a wroth while purchase for $133.00?
  5. C

    very intermitant stalling

    After removing and re-soldering the ECM power and ground connections on the ECM circuit board the stalling went away for 3 weeks, it has stalled once this week, but restarts right away. When it was stalling over the winter it was like the ECM fuse was removed in that the lift pump did not run...
Back
Top