Search results

show what I`ve been up to the last couple of years. Its a 2014 VW Amarok 4x4. Its got a 2.0 litre 4 cylinder turbo diesel motor and a 6 speed manual gearbox. It makes a little over 180 hp and 320 ft lbs of torque. I did a suspension lift (coils 2 inches) Bilsteins all round and just...

I´ve gone Euro by way of Argentina. I just purchased a new VW Amarok 4x4 double cab 2.0 turbo diesel pick up. Its got traction control and electronic locking diff. 6 speed manual trans. The best part is it gets over 30 miles to a gallon. So I just wanted to say thanks to everybody here that...

Cause codes 25 (accelerator pedal position 2 cicuit high),27 (accelerator pedal position 2 circuit fault) and 62 (turbo boost sensor circuit low) ? I stopped after driving in moderate to heavy rain for 8 hrs. One hour later off I went and the service engine lite came on and it quit boosting...

while its connected in the truck? I really don´t want to take it all apart. I can reach in from the blower motor and feel all the crud. I´ll go out and try to vac it out but it feels like the evap is clogged with mud? Thanks to all gus

mounts for my 1995? Any good online sellers out there? Thanks gus

I´m gonna replace the uppers and lowers both sides. What brand and supplier is best? I see Moog at Rock Auto for a decent price. Any good? There is quite a selection and this is my first time with the "95" so make and numbers would be greatly appreciated. Thanks g

How are these working? Do I need a new harness? Will my old heat sink work? Old resistors work? I´m on my last (of 5) PMDs. Thanks folks. gus

http://www.flixxy.com/volkswagen-levitating-car.htm

Just curious how the g80 locker works for you guys and gals? Durability? Does and donts?´Mine seems to work well. I rarely have to put it in 4 wheel drive. 14 bolt diff. Thanks gus

I can´t remember the name of the vendor that sold the dash board anle iron reinforcment chingaderas. It was flying something or another. Searched but came up dry. Thanks gus

I just had new General Grabber 265/75/16 AT2 e (load range) tires put on my 95 sub. The drive home was alot different than the drive there with my old Michelins. I checked the tire pressure and they were at 40 lbs all 4. Way too low for an 80 lb max tire I would think? What pressure would...

My rear A/C blower only works on the highest setting. I checked all the fuses and they are fine. Any ideas on what or were to check? Thanks g

My sub stalled right after start up 2 days in a row then driving about 10 miles it went into limp mode. I pulled over and shut the truck off after restart it was aok. I checked the codes and got 36 inj pulse width error long and 72 vehicle speed sensor loss. Any ideas ? I have a road trip coming...

Coming home outside of Guadalajara I lost cruise control,then OD , then I was pretty much reduced to 1st gear. I got home (very slowly) and have codes of 36 IP pulse error long and 72 vehicle speed sensor circuit loss.. Just prior to this I had a weird stalling after cold starts but it ran fine...

I was out shopping today for our vacation next week and I noticed a puddle of coolant under the exhaust. I got underneath and one of the heater hoses is leaking badly. My question is were is the best place to delete the rear heat? To me it looks like the Ts under the hood would be easiest...

I put a kilo of 134 in the system today because it wasn´t blowing as cold as it should. Now the light in the AC button doesn´t come on (it was working before the recharge) and its still not blowing as cold as it should:mad2:. The commpressor engages when the button is pushed in but no light...

The dust has finally settled and I have some time to write this. I went up to Cali from my home in Mexico for the holidays. It was 6 days of driving, three up and three back down. Just over 3500 miles. I left with a stock exhaust, flat airbox and 4 bad shocks. Oh yea and I had never had my...

That can time my injection pump? PM me please. g

I am still having random stalling problems and was sure it was the 2 PMDs I have. Well today I started checking fuel flow to see if maybe that was it. So I replaced the fuel filter and then checked my flow from the water drain valve I had none. I opened it all the way and the truck died. I...

Two weeks ago I started the truck and it imediatly died and did not want to start. After unplugging and plugging in the pmd in the front bumper it reluctantly started. So I figured another bad pmd story. It ran fine for two weeks. Well yesterday after driving it a 1/2 hour away for a 2 hour...