Search results

Do you have the pan removed? you can measure directly on the solenoids.

Connect the connectors and measure again

You need to disassemble the TCM and take a photo of the board on both sides.

yes on Red. And check pins 1 and 5 on the gray connector.

Is there voltage on the other connector pins 22, 24, 32?

Strange, it should always be on pin 3. not 2

Is there voltage on these contacts?

And you still have error P0748?

To measure the current you need to move the red probe to contact “A”. Mode switch to position "A".

I've already moved towards you.

Ideal 61-337 will be enough.

The first two pictures cannot measure current.

AstroAI Digital Multimeter TRMS 4000 Counts with DC AC voltmeter and Auto-Ranging Fast Accurately Measures Voltage, Current, Resistance, Capacitance, Temperature, Continuity, Frequency and Duty-Cycle. https://a.co/d/86wp6nR 1000V 20A Multimeter Test Leads Probes Banana Plug, Digital Multimeter...

And order other probes right away. Look what's on AliExpress! 1 Pair Silicone Universal Multimeter Test Leads Replaceable Multimeter Probe Test Wire Probe With Alligator Clip 1000V 20A for 792,60 ₽ https://sl.aliexpress.ru/p?key=qbcbUCd

Although for $18 it's better than that green one.

Better Fluke 87 or APPA103.

Do you have another multimeter? This one does not measure current. Or you need to purchase a shunt (a resistor with a very small resistance, for example 0.01 Ohm). I think the accuracy of your multimeter in resistance measurement mode is not very good.

The solenoid has two contacts, one contact is negative from the battery, connect the plus of the battery to one of the multimeter probes, connect the second multimeter probe to the second contact of the solenoid. In this case, the multimeter must be in current measurement mode and the probes...

Can you measure the distance between the teeth on your bolt? You need to count 10 teeth and measure the distance between them. should be exactly 15mm, congratulations. But if it turns out to be almost 16mm (15.87mm) then this SAE ⅜-16 bolt will not fit.

with a hairpin they were unscrewed evenly and tightly. Can't do it with your hands, with clamping pliers.