Search results

Hope you have your thumbs too. Unlike the table saw operator..

I always wanted to do something along those lines and end up with a flip front end similar to an International or Kenworth

We had a 4 door Caprice when first married. I don't remember what we did with it

Is it still hooked to the intake, to keep the vacuum in . The crankcase? Maybe without the suction. You're having more leakage. One of the reasons I never pursued a provent.

I think they skipped the fusible links on some of the aftermarket harnesses. Something I always wondered about Since getting married at 17, I've always been about protection.

Earl Shive's baked on finish. I can't believe that I don't remember the phone number.

An.electric gauge. I haven't found one I'm wild about yet. O e that showed vacuum would be ideal. It would clearly show when your lift pump wasn't working at all and you were just running off the injection pump. I would also like a combination dial and digital readout.

Not mine K35 air box setup, manual waste gate actuator, and a wicked wheel off my 96 k3500 All for $200 +shipping. Switched to a hx35 so this stuff is taking up space https://www.facebook.com/groups/551256768344622/permalink/3386433654826905/?app=fbl

I had a 1988 and a 1989 built in 1988, Chevy / Geo Spectrums. Good little cars. I probably should have done or got the timing belts changed. I was very neglectful and abusive of those vehicles to the tune of a few hundred thousand miles. Turning the AC on, was like throwing an anchor out the...

Welcome aboard. It's not only about diesels here

I figured. But was hoping not

Where are those made?

Nice score.

Is it still good other than that?

I've been around some drip oil heaters that worked pretty good

That's what I ran on duallies. I have 235/85/16s on the 1994 K3500 single rear wheels right now. Hopefully the last tires I ever put tires on it

I wouldn't trust any of them. Test and balance them all.

Do you have a link to quality clamps? I posted a link to some stainless, not worm gear clamps, years ago. Seems I'm out of some. Do you recommend the type of clamp you can tighten or spring clamps

We were in Menards and just stood by something in the store. Never mentioned it until it popped up

Parts cannon