Recent content by todd

:mad2::redneck::twak::feedback:ok i am sick of the pmd plague ! every time the better half gets near the damn burban it either runs out of fuel or the pmd dies or both !!!!! that being said i have a 95 puter 6.5 in the trk and a 94 on the stand in the shop,i am going to switch to a non pmd pump...

that chunk is kind of the end of that block. dont even try it you will wind up with a window in the block this is the voice of experiance! a differant block can be purchaced cheap usually at the local gm truck dealer they may have an old warrentee block laying around they will dump on you if you...

please define fsd

a few month ago my lift pump quit but it worked on a jumper wire so i ran it to a switch in the dash seemed fine but now the truck will just quit like the ignition waqs turned off. sometimes its fine but it is hard to start when hot when cold it starts fine and runs greight till it warms up then...

ok now i have to speak. as for lawyers thet are bottom feeders we all know that,as for govt motors we all know that they are unlikely to sue themselves we are all accountable for oure actions and as i was taught so are corporations at least till they buy corporate lawyers. as for my familly...

thank you all now i will just leave it alone and not worry

i did away with my vaccume pump, wow is it quieter !!!!!!! but i have something on the firewall above the master cylender it is flat on top has a vaccume hose and a wire harness plug on the bottom so far i dont have any lights in the dash and see no adverse effects from letting the hose just...

thanks now all i need is a fax # and what brand you want and i will fax it right over. lol

ok i am trying to follow this to the end that since i have the front off my baby right now i am hopeing to get a part number a hi volume wp if someone can give it to me i will fax them a beer

to start when i got the truck the rad was out so i sent it to be boiled hope its good, i did not use an ac t-stat and i guess between 200 and 220 to be 210 but i have picked up that i should start with an aftermarket gages so far she hasent heated up but didnt know if it would or not based on...

:cheers2:ok its in the 30's here and on a trip my 6.5 is running 200 deg i am concerned it will heat up when its in the 80's and i am pulling a load. what is a good cooling system upgrade maybe get rid of the fan clutch and go with a couple electric fans? dunno but will in a day or 2 thanks you...

a universal exaust retarder can be had aftermarket through dick laing diesel but it beats the engine also most ud,volvo,and nissan medium duty have the option so can be swapped ir u find one in a junk yard but if you do let me know what junk yard you use as i will wait and check ( i need parts...

4 days shop time !!!!!!!!!!!!!!! the owner had a new turn signall switch installed about 3 days b/4 we got it but neglected to mention that till we found it pinched in the collum after a new switch was installed a new pcm and countless hrs looking for the problem we really ate it on this one but...

turns out i was a pinched wire between the ignition and the ecm,when it made connection it was not full value the rest of the time the vehicle thaught it was stolen

ok i see a lot of mentions about hi idle does my 95 k2500 f suburban have one? if so what is the secret to setting it? i have played with the cruise like on a detroit or cummins but to no avail is it something i can add?