-
Welcome to The Truck Stop! We see you haven't REGISTERED yet.
Your truck knowledge is missing!
- Registration is FREE , all we need is your birthday and email. (We don't share ANY data with ANYONE)
- We have tons of knowledge here for your diesel truck!
- Post your own topics and reply to existing threads to help others out!
- NO ADS! The site is fully functional and ad free!
Problems registering? Click here to contact us!
Already registered, but need a PASSWORD RESET? CLICK HERE TO RESET YOUR PASSWORD!
Rodd's latest activity
-
RRodd replied to the thread Rebuild about done.I built it myself. I wasn't aware of the powder. I will ask them about it.
-
RRodd replied to the thread Stalling / Smoke.My son put one of the other Inj pumps we had in and it fixed the stuttering and smoking. He got it right at -1.93 right off the bat. no...
-
RRodd replied to the thread Rebuild about done.No. I didn't receive any powder with them. That wouldn't cause the discrepancy with the compression on each bank would it?
-
RRodd replied to the thread Rebuild about done.Just installed them. The machine shop gapped them when they resleeved the block and balanced everything. When my son pulled the pistons...
-
RRodd replied to the thread Stalling / Smoke.Thanks. If this doesn't work I'll check the orings on the FSU.
-
RRodd replied to the thread Stalling / Smoke.I realized that when I took the picture.
-
RRodd replied to the thread Stalling / Smoke.My son started pulling the IP and found one of the sensors came off the IP. Can we just reconnect? One screw is there. I have an old ip...
-
-
RRodd replied to the thread Stalling / Smoke.After reconnecting everything and topping off the coolant, it is still smoking. When we started it with no belt there was a puff of...
-
RRodd replied to the thread Rebuild about done.That's how I think I put them on. My son took the pistons out and I had him take them to the machine shop to make sure the rings were on...
-
RRodd replied to the thread Stalling / Smoke.I know. Especially since it has over 300k on it.
-
RRodd replied to the thread Stalling / Smoke.Put on a new Pulley and started it for 10 seconds with nothing connected and no smoke. That must have been it.
-
RRodd replied to the thread Stalling / Smoke.Here is the broken Pulley in front of the HB
-
RRodd replied to the thread Rebuild about done.Will that also cause compression issues? I thought they were all installed the same. The machine shop should see it if they are.
-
RRodd replied to the thread Stalling / Smoke.I will post shortly. Basically the key kept the HB in synch with the crank however the outer ring would move about 2 inches or so before...
-
RRodd replied to the thread Rebuild about done.Yes they are.
