Recent content by mrbucbuck

I'm in!!!!

If I'm not mistaking, yes, you must pull the axle shafts to remove the drums.

Usually with the passlock system, the fuel injection system is locked out and the engine is prevented from starting if the vehicle is hot wired or if the wrong key is used in the ignition.....try this; whenever it won't start, wait ten minutes with the ign. key on in the run position, then...

Do you have the anti-theft passlock system on your 97?

Yeah, what he said....I think. :rolleyes5:

Well, that same 'math' was what damned the ATT in the first place, these numbers said the turbo would never work on a 6.5........yet for all those who own one...I'll not go there. I have a headache, and you know why....well, I don't either. Just another point on how what's deemed to 'not' be...

Thats right, you said that earlier.....sorry bout that. Well, no fret, we all have nothing but time on our hands. Well, at least I do cause now I can go down the road with a load and get back sooooooooooo much faster now :D :grouphug: The 6.5 Family!

Kenny, Try to do a snap shot while its bogging down, as this might shed some light on the actual fuel rate requested @ throttle, plus IP timing, etc. Can't quite put a finger on it yet. I was hoping Buddy would chime in on this one....try to get a snap shot of running conditions using his PMD...

:You_Rock_Emoticon: Then the next thing you know, there will be a 'Cash for Duramaxs'..........):h:D

:iagree: :yesnod: :grouphug: The 6.5 Family!

So it wasn't reving up on it's own during the snap shot right?

:pat: Shouldn't be an issue.

:hmmm::yesnod: Revs with original PMD and not with a known working PMD......Kenny, check wiring harness loom, @ IP, rear of engine for loose connections, broken wires, etc. I would swap your 94 eprom with his...just to see what happens.

:dot: Ecm issue........

:smile5: I think if they knew then what we know now, well, they wouldn't have payments for a better performing truck! :eek:):h I can attest, I wouldn't dare think about 'PAYMENTS' in these troubled times, even tough there was a time when I didn't think my 6.5 would live long doing what I do...