Recent content by Hummer H1

Yea they do it here as well But they charge for half pint of paint plus the cab fee It comes out to be 40 ish 75 dollars depending on color code.

Will I think you are just jealous our vans don’t use alarm, we use pod locks and boobytraps

Yes any enamel / solvent paint will work

Lol hahaha

I will give you a little dirty experienced painters trick secret that I did on this van. this van was in bad shape, it needed full paint job, but it’s a work van, the paint code on this van is very expensive, 190 dollar a qt, it needed over 1.5 gallons to finish the job after primer. so I went...

It all depends on the condition of existing paint, painters techniques, low pressure or high pressure, silver based paints have low coverage compared to solid paints such as red or yellow or black. Good prep and mostly matching existing color, you can paint with 2qts it also depends if you are...

some local grow / hydroponics stores know people who sell there equipment Ask them too

Look up in Craig’s list or offer-app definitely get an LED light.

Yes if you connect the hand held back to TCU it will show all your settings, Don’t be afraid to click on them to view it won’t change the setting unless you press up and down arrow.

Yeah I would definitely use the factory TPS sensor

Make sure that shift points are not set to aggressive shift

There are two + 12v inputs for TCU One is connected to directly to the battery and the second one is for keyed 12v power at any given time there is power in the TCU When you turn off the key yes the hand held screen stays on because there is still power in the TCU

Go back to settings menu and start as a new tune See if you can change that You have to calibrate your TPS sensor again

Mine is set at 1800