I need some help. I have a 2004 Chevy colorado 4 cyl. base model. I am throwing code P0449 Evap emissions control system vent valve/sol malfunction. I changed the canister vent valve and cleared the code. I drove the truck to work (52 miles) without shutting the truck off and the code didn't...
when it's all warmed up at idle she runs fine, when I raise the rps to about 2500 or so she starts spitting and sputtering like crazy, when I let off the accelerator she's fine. took her out today and she acted up, especially going up a small incline, started sputtering and choking, and blowing...
:mad2: Well... I just can't seem to get this truck running right. She idles fine and cruises good, but when I get up to about 50 or 55 mph and 2000 rpm the tach needle starts going nuts like someone is feathering the pedal, then the tach drops to nothing like I took my foot off the pedal, but...
I have changed the lift pump twice, im sure that it's installed correctly, have changed the ops and the fuse(the one you can jump to keep the lift pump pumping) Don't have a voltage meter and not sure I would know how to work one if I did. where is the water drain?
Well here I am again begging for help, just can't seem to get it right. I blew out the fuel line from the engine side of lift pump to the fuel filter. Now I can't keep fuel in the fuel housing, it pumps up to the filter, and only runs until the fuel housing is empty. did I possibly blow...