Recent content by CheaperJeeper

Thanks for the link. I'll go through that this weekend and see what it turns up. BTW, I think I'll replace the fuel filters and the O-ring on the shaft of the air bleed valve - along with the OPS and relay - just for good measure.

T-valve? Is that the air bleed valve screwed into the top of the filter housing?

Well, now I don't know what to think. I jumpered the relay and had good fuel flow. Started right up. Then I put the relay back in and re-started it again - no problem - like nothing ever happened. The reason I find this so confusing is that I had already pulled and reinserted the relay a...

This is the setup I have in my truck. So, I'm thinking that if I jumper this relay, and it pumps fuel, that rules out the pump being the problem, right? If so, and it starts I have an OPS problem, but if it still doesn't start, then we're back to a PMD issue.

Anybody in the greater Seattle area (or better yet, south King/north Pierce county) area with a spare PMD I could try?

So just pull the plug up and out over the top of the original PMD?

Yeah, I'm well-versed in the evils of demon ether. I waited until the GPs cycled off before giving it a half second blast, let it crank a few seconds before giving another little blast, etc. I've found that with the proper juducious application a little ether can be very helpful starting a...

Yeah, I know. Ether is downright dangerous with these high compression motors. That is why I only gave it a little whiff - like a quarter to a half second blast at a time. The only spare PMD I have is a grey one, and from what I understand they aren't plug-n-play compatible with the black...

OK, 2 new discoveries to report. I took the fiberglass "shroud" off the top of the engine and between the pump and the firewall is a black filter housing abour 3" in daimeter. It has a knob on top that I unscrewed and removed. the knob has about a 1" long x 3/8" diameter tube on the bottom side...

I have a 95 3/4 ton Suburban, had it for a couple of months now, no issues (except for replacing the batteries). Truck is bone stock as far as I've been able to determine. 48 hours ago the wife drove it to haul a load of stuff to the recycling place. Started and ran just fine. Today she...

I sent you a PM too, ak diesel driver...

So it doesn't build up in the tank, right? LOL, that sounds just the kind of "secondary benefit" that some pencil-necked bean counter would come up with (the $2 per unit manufacturing cost savings being the first benefit, of course). After driving it for 7 days worth of commuting it got down...

Box and pre-paid return label are on their way...

ak diesel driver: I got your PM and am ready to send the box out to your brother. Just one question - is the address you gave me his home adress or is it his business address? I'll need to know when I print the label to ship it to him. On the UPS web site where you create the shipping label...

That's the waterproofing I was talking about. I hate the idea of gluing it to the heatsink and the possibility of it not being water-tight...